MRSpivey Posted November 13, 2017 Author Share Posted November 13, 2017 If you think about on time in pulse firing being the pulse width/duration and that gets repeated over and over the hole time you are holding the fire button. That is how you effectively change the voltage going to the atomizer. The longer the pulse on time the higher the effective voltage and the opposite applies too. Link to comment Share on other sites More sharing options...
MRSpivey Posted December 5, 2017 Author Share Posted December 5, 2017 Finally finished except the cleaning. Had to replace multiple parts multiple times but finally working as it should. Barely able to fit everything into the housing. Link to comment Share on other sites More sharing options...
cany Posted December 5, 2017 Share Posted December 5, 2017 Looks Great MRSpivey 1 Link to comment Share on other sites More sharing options...
MRSpivey Posted December 5, 2017 Author Share Posted December 5, 2017 Looks GreatThank you. Link to comment Share on other sites More sharing options...
Walt Posted December 5, 2017 Share Posted December 5, 2017 Lookin Good!!! Link to comment Share on other sites More sharing options...
MRSpivey Posted December 6, 2017 Author Share Posted December 6, 2017 Thanks Walt. I learned a bit with this that will enable my next one to turn out better cosmetically. Walt 1 Link to comment Share on other sites More sharing options...
Walt Posted December 6, 2017 Share Posted December 6, 2017 1 minute ago, MRSpivey said: Thanks Walt. I learned a bit with this that will enable my next one to turn out better cosmetically. Well then, I can't wait to see the next one because this one looks pretty sharp to me. I dare say you're getting good at this. Link to comment Share on other sites More sharing options...
MRSpivey Posted December 31, 2017 Author Share Posted December 31, 2017 Here are the latest Pics: Lessons Learned:1) Always test components individually after soldering (from original fire switch failure)2) Calibtate the LED DVM before installation (self explanatory)3) Don't flex Potentiometer leads, they break easily (self explanatory)4) Use the right tool for the job (center punch - couldn't find and freehand drilled holes, wrong Dremel cutting wheel for meter opening, and drill bit just one size too small for replacement button)5) Always me mindful to protecting the finish on the Mid Box (protective tape, towel, paper towels, or multiple things to keep from scratching finish)6) Laser engraving/etching should be the last thing done, not the first (related to #5 anbe)7) Don't use heaver gauge (oversized) wire just because you think bigger is better (it takes up space!)8) Case size does matter, allow extra! Link to comment Share on other sites More sharing options...
Walt Posted December 31, 2017 Share Posted December 31, 2017 37 minutes ago, MRSpivey said: Lessons Learned: Looks real sharp to me. Glad you got a lot of "take home" experience though. I think about learning new joining configurations in wood working. Oh my. A lot of wasted wood and some hair loss. But once all the techniques are down, some damn nice results. MRSpivey 1 Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now