9mmBiscuits Posted May 19, 2016 Posted May 19, 2016 So this is a new thing on the display for me. I've had this setup for over 6 months now. Yesterday I changed the coil and put in a new factory built Kanger OCC 0.2 ohm coil. After prepping the coil and putting everything back together and letting it sit for a few minutes I went to fire it and the display read "shorted." I'm guessing it's the coil, but not entirely sure. Any thoughts? Thanks.
Squid Posted May 19, 2016 Posted May 19, 2016 Do you have it in wattage or tc mode? Not sure of the specifics on that device, but it may not recognise a .2 coil in wattage mode. The .2 kanger coils are ni200, and should only be used in TC mode. Or it could be a bad coil, it happens from time to time.
9mmBiscuits Posted May 20, 2016 Author Posted May 20, 2016 It is in wattage mode. Ok, that's new to me. I've used them in wattage before but maybe that's finally catching up with me.
Bebop Posted May 20, 2016 Posted May 20, 2016 Accident waiting to happen. Get new coils and do not run that coil in wattage mode
9mmBiscuits Posted May 20, 2016 Author Posted May 20, 2016 17 hours ago, Bebop said: Accident waiting to happen. Get new coils and do not run that coil in wattage mode Thanks for the help!
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now