NewlyVapeLover Posted January 28, 2016 Share Posted January 28, 2016 I am a newish vaper, my old roommate had given me her old ecig and I got started on that one. I now have an Itaste VV4 paired with a Protank 2 from Kangertech, and coil with 2.2 ohm. What's the highest I should go in voltage and highest I should/can go in wattage?? Link to comment Share on other sites More sharing options...
Tam Posted January 29, 2016 Share Posted January 29, 2016 You set either the volts OR watts, you go with one at a time, not both at the same time -- if that makes any sense. So, if you're in wattage mode, set that. Leave it at that. As for the "highest" you should go in watts or volts, start low and vape. If that doesn't do it for you, turn it up a little. Vape. Keep repeating that until you get a slight burnt taste or a harsh vape. Turn it down just a bit and that will be the sweet spot for that tank-coil-juice combination. Each one will be a little different so you'll just adjust each time. I've noticed that fruit flavors like lower heat while bakery flavors/coffee flavors like it hotter. NewlyVapeLover 1 Link to comment Share on other sites More sharing options...
Earthling789 Posted January 29, 2016 Share Posted January 29, 2016 "Each time" Tam is referring to is each time you change coils, or change to a different juice. Lower resistance coils like 1.5 or 1.8 will require a little more power (Wattage) than the 2.2 Ohm coil you're using now. The one you're using now is a cooler coil... it takes a little longer to heat up, but is good for long draws because it heats slower. If you want a little more heat, you may want to try a 1.8 Ohm coil... most of us prefer those in the KPT2. Also, adding a Kanger air-flow-control base to your tank will give you more air-flow and is adjustable to make the vape more personalized. The bases can be found online or at most shops for $3-7, and make your KPT2 that much better! Welcome to Vapor Talk! NewlyVapeLover and Tam 2 Link to comment Share on other sites More sharing options...
NewlyVapeLover Posted January 29, 2016 Author Share Posted January 29, 2016 @Tam Yes, I do know I can't do them simultaneously, thankfully that wasn't hard to figure out. I have a 2.2 coil, is 1.8 better for stronger taste and heat? The ecig did come with a "beauty ring" as well... Link to comment Share on other sites More sharing options...
Tam Posted January 30, 2016 Share Posted January 30, 2016 13 hours ago, Earthling789 said: "Each time" Tam is referring to is each time you change coils, or change to a different juice. Lower resistance coils like 1.5 or 1.8 will require a little more power (Wattage) than the 2.2 Ohm coil you're using now. Thanks for clarifying that, Earthling. Okay, it's been a long day and even longer week, and please correct me if I'm wrong but wouldn't a lower resistance coil use less power to heat up due to the lower resistance in the wire? Link to comment Share on other sites More sharing options...
Earthling789 Posted January 30, 2016 Share Posted January 30, 2016 12 minutes ago, Tam said: Thanks for clarifying that, Earthling. Okay, it's been a long day and even longer week, and please correct me if I'm wrong but wouldn't a lower resistance coil use less power to heat up due to the lower resistance in the wire? Been a long week for me too, Tam... I totally empathize If Wattage is held the same, the lower resistance coil will draw more Amps, because it has less resistance. At 10W of power, a 2.2 Ohm coil draws 2.1A, and the 1.8 Ohm coil draws nearly 2.4A. The lower resistance coil will heat and cool faster, which is great if you chain-vape, so you aren't cooking the juice with a coil that stays hot longer. For a casual hit with a long draw, the higher resistance coil is better suited, IMO. Both are so close to not really have much difference in power consumption, but the 1.5-1.8 Ohm coils are a good starting point for the new vaper... Most people will use a higher Wattage with the lower resistance coil, to achieve a better vape (flavor, vapor production, warmer), so the lower resistance coil will require even more Amps (power) because you'd likely dial it up to 12-13W (if 10W tasted good on the 2.2 Ohm coil). jasonculp and Tam 2 Link to comment Share on other sites More sharing options...
Tam Posted January 30, 2016 Share Posted January 30, 2016 2 minutes ago, Earthling789 said: Been a long week for me too, Tam... I totally empathize If Wattage is held the same, the lower resistance coil will draw more Amps, because it has less resistance. At 10W of power, a 2.2 Ohm coil draws 2.1A, and the 1.8 Ohm coil draws nearly 2.4A. The lower resistance coil will heat and cool faster, which is great if you chain-vape, so you aren't cooking the juice with a coil that stays hot longer. For a casual hit with a long draw, the higher resistance coil is better suited, IMO. Both are so close to not really have much difference in power consumption, but the 1.5-1.8 Ohm coils are a good starting point for the new vaper... Most people will use a higher Wattage with the lower resistance coil, to achieve a better vape (flavor, vapor production, warmer), so the lower resistance coil will require even more Amps (power) because you'd likely dial it up to 12-13W (if 10W tasted good on the 2.2 Ohm coil). Wow. And I even followed all that. I was basing it on my vaping style, which is to use a 1.8 ohm coil but only at 8W. I go up to 9.4W when I'm feeling adventurous. jasonculp 1 Link to comment Share on other sites More sharing options...
Earthling789 Posted January 30, 2016 Share Posted January 30, 2016 6 minutes ago, Tam said: Wow. And I even followed all that. I was basing it on my vaping style, which is to use a 1.8 ohm coil but only at 8W. I go up to 9.4W when I'm feeling adventurous. 9.4W is adventurous? Well, I'm not much better... I mostly run 1.2 and 1.5 Ohm factory coils, and build my RBA's to 1.0-1.4 Ohm, which means I hover my MODs between 12 and 20W for the most part No wonder you love those iStick 50W boxes... at 8W, I bet they last you 4 days between charges Link to comment Share on other sites More sharing options...
Tam Posted January 30, 2016 Share Posted January 30, 2016 3 minutes ago, Earthling789 said: 9.4W is adventurous? Well, I'm not much better... I mostly run 1.2 and 1.5 Ohm factory coils, and build my RBA's to 1.0-1.4 Ohm, which means I hover my MODs between 12 and 20W for the most part No wonder you love those iStick 50W boxes... at 8W, I bet they last you 4 days between charges Yep. I've gone the subohm, high watts route but don't like the warm to hot vape. Cooler is my sweet spot. Even chain vaping, the iStick 50W lasts between 4 and 5 days between charging. Earthling789 1 Link to comment Share on other sites More sharing options...
NewlyVapeLover Posted January 31, 2016 Author Share Posted January 31, 2016 So 1.8 is lower resistance? Sorry this kinda thing hasn't stuck for me yet. This itaste VV 4 goes through coils very quickly it seems like, I had been getting that nasty burnt taste, and was trying to understand it and found another coil in the kit it came in. I put that coil in and very quickly the wicks became gunky. I washed it off but I don't know what i'm doing wrong... Link to comment Share on other sites More sharing options...
FXRich Posted January 31, 2016 Share Posted January 31, 2016 If the coil is getting gunky very quickly it could be the juice you are using, some juice will gunk up a coil faster than other juices. Link to comment Share on other sites More sharing options...
NewlyVapeLover Posted January 31, 2016 Author Share Posted January 31, 2016 9 minutes ago, FXRich said: If the coil is getting gunky very quickly it could be the juice you are using, some juice will gunk up a coil faster than other juices. Aw. dang i'll have to try a different one once I get new coil, since when i cleaned this one it would not come real clean, barely could get gunkyness off Link to comment Share on other sites More sharing options...
FXRich Posted January 31, 2016 Share Posted January 31, 2016 I mix my own juice and the only difference basically is the flavor and have noticed that some gunk it up more than others. When I use a flavor that gunk's up the coil fast I add a few drops of water to it and it seems to help some. NewlyVapeLover 1 Link to comment Share on other sites More sharing options...
NewlyVapeLover Posted January 31, 2016 Author Share Posted January 31, 2016 hmm. I got my current one from Vapor street on hampton ave in Missouri. it's called cinnamon... Link to comment Share on other sites More sharing options...
FXRich Posted January 31, 2016 Share Posted January 31, 2016 Do you know what the PG/VG ratio is or is it not stated on the bottle? Link to comment Share on other sites More sharing options...
NewlyVapeLover Posted January 31, 2016 Author Share Posted January 31, 2016 not stated. all i know is he had to custom mix it cause they didn't have 3mg nicotine premixed Another flavor i have is irish creme from Zeus E-juice and it's60% Pg and 40% vg Link to comment Share on other sites More sharing options...
Tam Posted January 31, 2016 Share Posted January 31, 2016 Darker, sweet juices will gunk up a coil faster than something that's light in color and not as sweet. I can use the same type of coil with a cucumber/mint juice for over a month and it will perform just as well as when I first put it in. That same coil used with a chocolate candy flavor gunks up within one week's time. Take that coil that you rinsed in water and soak it in some vodka or Everclear overnight. Rinse and let dry another night. That should help ungunk it. Link to comment Share on other sites More sharing options...
NewlyVapeLover Posted January 31, 2016 Author Share Posted January 31, 2016 Just now, Tam said: Darker, sweet juices will gunk up a coil faster than something that's light in color and not as sweet. I can use the same type of coil with a cucumber/mint juice for over a month and it will perform just as well as when I first put it in. That same coil used with a chocolate candy flavor gunks up within one week's time. Take that coil that you rinsed in water and soak it in some vodka or Everclear overnight. Rinse and let dry another night. That should help ungunk it. I'm 20 ... i don't have any vodka Link to comment Share on other sites More sharing options...
FXRich Posted January 31, 2016 Share Posted January 31, 2016 Does the Irish Crème gunk up the coils too? Most people notice the darker the juice the more it messes up a coil. The 60/40 mix seems to be a good mix for most people. Link to comment Share on other sites More sharing options...
NewlyVapeLover Posted January 31, 2016 Author Share Posted January 31, 2016 I don't know, the coils were already gunked up by the time i thought to try it... Link to comment Share on other sites More sharing options...
Tam Posted January 31, 2016 Share Posted January 31, 2016 Just now, NewlyVapeLover said: I'm 20 ... i don't have any vodka Well, dang. Try rinsing the coil under very hot water, soak it until the water turns cool and then let dry overnight. That should help better than nothing. NewlyVapeLover 1 Link to comment Share on other sites More sharing options...
NewlyVapeLover Posted January 31, 2016 Author Share Posted January 31, 2016 Just now, Tam said: Well, dang. Try rinsing the coil under very hot water, soak it until the water turns cool and then let dry overnight. That should help better than nothing. Ok i'll give it a try before I go to bed! Link to comment Share on other sites More sharing options...
FXRich Posted January 31, 2016 Share Posted January 31, 2016 I have heard that some people boil them, I haven't tried it, but it might work. Link to comment Share on other sites More sharing options...
NewlyVapeLover Posted January 31, 2016 Author Share Posted January 31, 2016 i don't have access to a real kitchen, i'm in a dorm Link to comment Share on other sites More sharing options...
FXRich Posted January 31, 2016 Share Posted January 31, 2016 Coils for a protank are fairly cheap, so if you can't clean them it may be best to buy new ones. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now