FXRich Posted January 17, 2016 Share Posted January 17, 2016 I received my Kanger 120 TC yesterday and have been messing with it a lot. It seems to be solidly built, and uses 2 18650 batteries in series, I believe they are in series because one battery goes +up the other goes +down. The battery door fits really well, and is a little difficult to get off the first time. It has 4 TC modes besides wattage mode, Ti, Ni, NiCr, and SUS, SUS is the Chinese way of saying SS. I have only tried Ti, and SS 316L coils so far, the Ti coils will make it pulse very noticeable, the 316 coils don't seem to pulse at all, except you can see the watts change in the display. Another thing is the TCR curve for the SUS mode seems to be for SS 304, when I set the TC for SUS I have to set it about 50 degrees lower than what I want it to be. Right now I set it between 350f and 390f depending on the juice I'm using, which means its running from 400f to 450f going by Steam engine calculations. The firmware is upgradeable so maybe in the future they will have a upgrade changing it to a 316L curve. In the end I have to say its a well built mod, but a little bigger than I prefer, its only 1mm thicker than the Kbox mini, but 2mm taller and 17mm wider. It will make a good at home mod. Its probably the same as the Kbox 200w TC mod, but I decided on the 120 because I don't need 120 watts much less 200 watts, besides they didn't have the 200 in stock, and its about $10.00 more. Vic 1 Link to comment Share on other sites More sharing options...
Vic Posted February 20, 2016 Share Posted February 20, 2016 Thanks, I was thinking about buying this mod!! I never go over 65 watts myself. Link to comment Share on other sites More sharing options...
FXRich Posted February 20, 2016 Author Share Posted February 20, 2016 It is a good mod, when I got it I put 2 new LG HG2 batteries in it and haven't taken them out. I just charge the batteries in the mod, a charge lasts me 2 to 3 days. The single battery mods I have I change the batteries in them and use a separate charger to charge them. I figure the best way to keep the 2 batteries married is to just leave them in the mod. I have 3 Kanger 75w TC mods and 2 Kanger50w mods so its not a issue to wait for the 120w to charge. The NiCr mode does work for Kanthal too, after I used a Kanger Clapton coil in power mode I tried it in NiCr mode, set it at 350f when I finally ran out of juice the cotton didn't burn. Vic 1 Link to comment Share on other sites More sharing options...
Recommended Posts