Clearomizer won't work

[dutchboy6804]

I installed a brand new e-goT clearomizer on a fresh battery , when I push the button it blinks 3 times and then nothing . 

Could this be a bad clearomizer ? Battery works well with other clearomizers .

[Compenstine]

May be you are not getting contact to the battery. Very carefully take a paper clip and pull the center pin of your battery up just a bit. Not to much or your will brake the wire inside the battery that connects to that pin. Be very careful!!!! It don't take much to make the connection!

 

[dutchboy6804]

Thanks for the tip Compenstine , have two batteries , both work fine with other clearomizers , just won't work with this particular iclear16 .

[Tam]

If pulling the pin up like Comp suggested, the next thing I would try is to replace the coil with a new one. Sometimes you get a bad coil...

[Compenstine]

That is very true could be a bad coil as well. At least with the Iclear 16's you can change the coil. It may be the coil was not fully installed at the factory. Had that happen to me once that the coil head was not screwed down all the way.

[dutchboy6804]

Thanks Tam , replaced the coil and all is well . ( love the knowledge on this site . )

[Tam]

Good grief and bless your heart. I'm not even communicating with full sentences tonight, but I'm glad you understood what I meant and that it worked for you. 

[lisazeng]

yean ,sometimes the coil is so bad ,hate it