i just started vapeing

[jesse newton]

My question is I got an evict vtc mini and its nice I didn't care for the tank it came with and got a kangertech sub tank mini and I tried the nickel coils for variable temp and that worked nicely but I noticed that the mod I got the update from joytech the 200 one and even befor that the coil head read 0.15oms but the mod read it as a 0.73oms and it hapend when I switched it to the regular coil head the kangertank comes with I'm using the 15 to 60 watt coil heads that are a 0.5om but my mod first ead it as a 0.72om and is naw reading it at a 0.69om and was wounding if I should continue  use if the mod is not reading it correctly

[eLCruz]

If the tank that came with it reads correctly, the problem may be the subtank base. I have a subtank plus and use nickel coils on it on my evic vtc mini and get exact ohm readings. So there may be something wrong with the subtank coil base.

[Bebop]

Make sure coil id seated in base firmly. Change mode to temp Ni and reattach tank to mod. Also make sure coil is cool when you reconnect it to mod.

Once it reads the coil correctly, use " lock resistance" feature.  That should do it.

[jesse newton]

Thank you for answering I tried resetting the coil head and it still read the same 0.69oms but on wattage its reading 0.64oms I have even reset the atomizer and still get that reading so should I replace the tank or get a different tank just curious if ther is something wrong with the mod but I dont think there is because I put the ariganle tank on it and it did fine any suggestions on tanks a coils I should use other then the ego one mega

 

[FXRich]

It might be a bad coil, the coils that come with tanks are sometimes bad.

[eLCruz]

The positive pins sometimes are Wonky on tanks. It may be making a bad / loose connection. I had to extend the positive pin on my herakles tank with a dab of silver solder cause it had a jumpy Resistance.