Jump to content

HexOhm V3 box mod Review


Tug

Recommended Posts

The Hexohm V3 is an aluminum box mod.It is 106mm tall,24.7mm thick and 53mm wide.The battery sled is very clean and neatly assembled.This device has a maximum output of 180watts and takes two 18650's.The voltage can be adjusted from 3.5v-6.0v.This device has a Panasonic MOSFET just for safety(which is extremely important).The specs that came with this device are very vague.But from what I'm reading this will safely fire down to a 0.15ohm resistance.The screen only displays voltage.Thats all,it doesn't show battery life or resistance.It has a voltage regulator dial on the side of the device to tune to your liking.The button is nice and clicky and it has very little ramp up time when you fire it .The battery door has four nice strong magnets and proper battery venting on the bottom of the device.The 510 is  very similar to the fat daddy vapes style and the pin is spring loaded.Its a very simple design and straight to the point,no complicated settings or any of that.Im pretty certain this is a clone but honestly it is built so well I can't tell much of a difference.Every tank or RDA has sat perfectly flush for me on this device.I really have enjoyed the Hexohm V3 and I really don't have anything negative to say about it.This was sent to me from GearBest.com.So go check out their site if you're interested in this device or any other vape gear.Thanks Guys! 

image.jpeg

Link to comment
Share on other sites

×
×
  • Create New...

Important Information

Terms of Use Privacy Policy Guidelines