Coils not working

[Eric]

I wanted to use the Anyvape .03ohm coils with my Cloupor mini box mod because it goes up to 30watts and the Anyvape .03ohm coils fire between 10 and 40watts so it would of been perfect but apparently they don't work with my 30w Cloupor mini mod.....I'm so upset. The screen kept saying something like "short circuit" or "low resistance" I believe so too. What the hell!!!! The Cloupor 30w mini box mod doesn't fire .03ohms coils???? You got to be kidding me!!!!

[Squid]

Copied and pasted from product description of a seller:

Main Features:
Output power: 7W-30W
Removable 18650 battery (not included)
Output voltage: 3.6V—7.0V
Vaping time counting ( 15S limited protection )
Pass through (can vape while charging)
Can build on 0.45-3.0 ohm atomizer
Adjustable 510 Pin
Ohms reading precision to 0.01ohm
Reverse battery protection , no worry about installing battery improperly
Left and right mode
Magnet back cover, no need to use screwdriver, more convenient
Instead of screen lock, it can be turned off
Over charge protection

Lowest resistance stated is .45, so no the .03 wont work. That is a pretty low resistance, ni200 coils for the subtank are .12, and the ni200 coils for the ego one are .17.

Edited October 3, 2015 by Squid

[Earthling789]

^^ This ^^

I have several of the Cloupor Minis, and they are designed to be used with Kanthal-wire coils, and can only run down to 0.45 Ohm.  They are not TC (temp control)

However, the Cloupor mini-plus (50W) and Clourpor Mini GT (80W) ARE Temp-control mods, and can fire coils down to 0.1 Ohms (for both), so neither of these will fire a 0.03 Ohm Ni or Ti coil

Edited October 5, 2015 by Earthling789