cany Posted September 14, 2015 Share Posted September 14, 2015 Ok where can I get the little ball bearing that locks the airflow control in place I seem to have lost it. I have the ball from a pen in now but its a bit too small Link to comment Share on other sites More sharing options...
FXRich Posted September 14, 2015 Share Posted September 14, 2015 You probably can't get one from Kanger, I would try steel shot the kind reloaders use, might find one the right size. I had no idea you could take it apart that far I normally just rinse it off with hot tap water dry it off and use it. Link to comment Share on other sites More sharing options...
cany Posted September 14, 2015 Author Share Posted September 14, 2015 I used the ball out of an old yellow ink marker so far so good lol. Rich I accidently screwed that section apart lol Link to comment Share on other sites More sharing options...
Tam Posted September 15, 2015 Share Posted September 15, 2015 I'm with Rich, didn't know you could pull it apart that far. lol Link to comment Share on other sites More sharing options...
FXRich Posted September 15, 2015 Share Posted September 15, 2015 I feel cheated I can't unscrew mine. I haven't tried the vise and pipe wrench yet though. Link to comment Share on other sites More sharing options...
cany Posted September 15, 2015 Author Share Posted September 15, 2015 Hold the bottom section of the setion of the airflow and the top unscrew the bottom section Link to comment Share on other sites More sharing options...
Tam Posted September 15, 2015 Share Posted September 15, 2015 I feel cheated I can't unscrew mine. I haven't tried the vise and pipe wrench yet though.Try the big hammer, Rich. That usually does it for me. Link to comment Share on other sites More sharing options...
Bebop Posted September 15, 2015 Share Posted September 15, 2015 Hold the bottom section of the setion of the airflow and the top unscrew the bottom sectionBut dont do that because the little bearing will fall out. Seriously, that sucker is like the eyeball of a gnat. Mine cones off easily and I have to make extra effort not to unscrew base incorrectly or that thing flys off.It will work without the bearing, it just won't "click" in to place. Link to comment Share on other sites More sharing options...
FXRich Posted September 15, 2015 Share Posted September 15, 2015 I got it to unscrew but didn't unscrew it, don't want to lose the ball. I'm good at taking things apart and not getting them back together right. Think I might just leave it alone. I always have spare parts when I put cars back together. Earthling789 and Bebop 2 Link to comment Share on other sites More sharing options...
Earthling789 Posted September 23, 2015 Share Posted September 23, 2015 I got it to unscrew but didn't unscrew it, don't want to lose the ball. I'm good at taking things apart and not getting them back together right. Think I might just leave it alone. I always have spare parts when I put cars back together.Grandpa always said... if you don't have something left over, you didn't do it right FXRich and jasonculp 2 Link to comment Share on other sites More sharing options...
Squid Posted August 9, 2016 Share Posted August 9, 2016 Ever find a replacement? I just had the same issue with my subtank plus. Going to fill it and before I knew it the little ball tink tink tinked itself across the garage floor and into the unknown. Tried the last known area with a magnet out of a hard drive with no success. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now