Replace wicks

[bigdog0531]

I have an Itaste MVP 2.0, does anybody have a good watt and volt setting? And how often should I replace my wick? Thanks

[Earthling789]

The sweet-spot for Wattage settings will depend on the juice you're using, and the resistance of the coil (and to a small degree the tank you're using).

Use this charts below as a good reference, but as always, start a new coil/juice out at low Wattage settings, vape, bump up the Watts, vape, repeat... until you get a slight burnt taste, and then back-off the power by 0.1-0.5 Watts... that should be the sweet-spot.

The interval for replacing the wick/coil is not set in stone.  Some coils will last for days, some for weeks, some for hours.  But, when the flavor starts to diminish, or the draw becomes tighter, it's probably a good indication to change the wick (on an RDA/RTA) or replace the COIL on a standard tank (like KPT, Nautilus, etc.)

[cesar]

Nice chart, I normally do it by taste, I start low and keep going up to I hit the sweet spot...  I will also add, that sometimes when the flavour starts to diminish the coil may need a dry burn to clean the wicks...I been using my current coil for 3 months, and still working fine.

[cesar]

I just realized that you using the same battery as me... so I can give you a reference point..

I use U3.8  / P8.5 for 1.7 resistance e-liquid with higher PG levels, and U3.5 / P8.0 for 1.5 resistance with lower PG levels. It works for me, it may work for you too.