Natulis Mini help

[cany]

Does anyone know if theres a seal/O-ring that goes down inside the air control valve?

[cany]

Had a bad leak last night while it was sitting I was wondering if I lost something when I cleaned it

[Earthling789]

No o-ring that I'm aware of, but I can tell you that my Nautilus (full-size) leaks like crazy when left sitting in the rack for more than a few hours, especially if not tip-top full...   I've had to clean up juice leakage more than once from under it

[cany]

Ive had it sitting for a few hrs on my toolbox and no leak yet. Maybe when I cleaned it/put new coil in I didnt tighten the coil enough :rolleyes:

[cany]

Forgot to add the coil was flooded bad also

[Earthling789]

Yep, I've found the BVC flood faster than the BDC, but they both flooded, and eventually leaked for me.  Hopefully, not having it snug enough was the issue for yours.

[cany]

In the week I had it It never leaked only after I cleaned it and changed the coil. I thought maybe I lost something  using the air blower at work to dry it off

[Squid]

There is an oring on the atomizer, a new one comes on each atomizer. At least every one I've bought does. Never had an issue with leaking in the 3 months I have had mine. I keep it in my shirt pocket on a VTR most of the time.

[cany]

Had it sitting off batt for about 6 hrs and no leaks

[kfolse107]

When changing a coil, I make sure to clean any juice inside the base where the spring is with a paper towel.

[ecignut]

I have never had a leak on my Nautilus mini since I started to use it - it is a great tank - the only problem I have is taking the base off to fill it - sometimes it is really tight even although I only finger tighten when putting it together again.

[cany]

I have never had a leak on my Nautilus mini since I started to use it - it is a great tank - the only problem I have is taking the base off to fill it - sometimes it is really tight even although I only finger tighten when putting it together again.

Yeah mines a real pain to get loose sometimes too

[ecignut]

Hi Cany - I think the problem is the same threading direction as when you fit the tank onto the mod and you then tighten it even more.

[cany]

Hi Cany - I think the problem is the same threading direction as when you fit the tank onto the mod and you then tighten it even more.

Ahhh over tightening without realizing it :wallbash:

[ecignut]

Even when you know about it the problem remains - it is a hard one to solve - I have tried just holding the base to put it on the mod but still have problems.

[cany]

Guess we just gotta deal with it :yes

[ecignut]

Yes I guess so - it is still the best tank but the coils can be inconsistant some lasting two weeks others only about 8 days. The K1 which is my other tank has the same kind of BVC coil but a smaller edition - I have the same problem with that as well - both tanks are worth the problem though - great taste at low power.

[cany]

Ive only had it about 2 weeks I think still on original coil I go back n forth with my KPT2

[ecignut]

Well here's hoping you have better luck than me.