HOOKER Posted April 1, 2015 Share Posted April 1, 2015 sooo I been having problems with AR mod either not firing or pushing real hard on button to get the thing to fire,, but when it fires its an OMG TOOT!!! had to do some investigating to figure problem out... I didnt want to unscrew the copper from the bottom side of 510 connector out tooo much (could crush the battery top in)... took my trusty digital calipers out & found that the diameter of the firing pin was larger than the inside diameter of the plastic sleeve wrap on battery therefore not allowing firing pin to make good contact with bottom of battery.... with Xacto knife I sliced the sleeve to the outside edge of battery without destroying the integrity of the sleeve wrap itself... now it hits hard time after time with absolutely ZERO misfires... Link to comment Share on other sites More sharing options...
Mirage Posted April 1, 2015 Share Posted April 1, 2015 Gotta go look at mine now... Link to comment Share on other sites More sharing options...
Mirage Posted April 1, 2015 Share Posted April 1, 2015 Hummm, my vtc4's seem to have plenty of room. Keep an eye on that wrap to make sure it doesn't start peeling up the sides Buddy. Link to comment Share on other sites More sharing options...
HOOKER Posted April 1, 2015 Author Share Posted April 1, 2015 I was concerned about the peeling,, I filleted the bottom wrap off leaving enough (I think) wrapper to hold it securely... Link to comment Share on other sites More sharing options...
Mirage Posted April 1, 2015 Share Posted April 1, 2015 Good deal. Worst case, you'll just have to rewrap. Shouldn't be to hard to do. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now