Monkeyman Posted January 2, 2015 Posted January 2, 2015 My Evolv DNA30 board was new about 2 months ago (replaced @ 3 months under warranty). About a month ago, I started having an intermittent issue with the ohms symbol not displaying although the correct resistance would display. Rebuilt my Kayfun tonight and now it's reading 0.00 ohms. I wrapped my coil at about 1.3 ohms so I know it's not too low. Has anybody else had an issue with the DNA30 chips? The mod manufacturer warranty is 4 months so this is now out of warranty. I don't feel like paying $80 (plus shipping) for them to replace the board (again). Any suggestions?
Compenstine Posted January 2, 2015 Posted January 2, 2015 pull the battery if you can. let it sit for min and then put the battery back in. That will reset it. It may be that you have a short in your coil. if you have a factory coil tank, try it and see if it reads the same as the kayfun.
Earthling789 Posted January 2, 2015 Posted January 2, 2015 Check your MOD's top-pin too... Floating pins can be pushed too far down, and sometimes spring-loaded pins can stick and not make contact.with the atty.
Tam Posted January 2, 2015 Posted January 2, 2015 Just a thought, what are you using to measure the coil's resistance? Have you tried something else to make sure your first measurement was correct? spydre 1
spydre Posted January 3, 2015 Posted January 3, 2015 ^^ What Tam said. Don't depend on your mod to read the resistance from your coil - could be a problem with the coil, not with the DNA 30 board. You have a separate tester?
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now