Mutation X

[Brandon76]

Quick question. I just bought MX and was wondering if anyone has one and are you running dual or single coils on it? I'm planning on running this on my Stingray.

[SALTLIFE]

Definitely duals. That atty was made for super sub ohm builds at the wide open setting.

[Brandon76]

Thanks. I built a dual coil and it read as .55ohms. Trying to figure out how many wraps I need to do. I'm using 28g kanthal. Might have to buy some different sizes. The flavor and vapor production is awesome I picked up some 30/70 juices at 6mg nic today

[SALTLIFE]

with 28g try a parallel. Two strands for each coil. I use a 3mm screwdriver to wrap on. Not sure what it will ohm out to cuz I mostly use low resistance wires but it should be lower them .5

[Monkeyman]

I have the v2 (no idea what the difference is between the v1 and v2). I've run both single and dual coils. I think dual coils work a little better but a single works pretty well, too. Just make sure you close off the non coil side if you're only running a single.

[SALTLIFE]

Top cap on v2 has diagonal air slots anf its a bigger drip tip. Standard tips do not fit in the v2 top cap. Also the screws have triangular heads. The v2 comes with a tool to fit but its very soft and cheaply made. And the deck looks like a Plumeveil with 4 posts.

[Brandon76]

Salt how many wraps do you do on the 3mm screwdriver? Right now I've been building my dual coils with about 4-5 wraps each. I need to soak and clean my Russian 91% has this month flavor in it from the last juice I tried. Might just soak it over night to see if that cleans it up and gets the flavor out of it.

[SALTLIFE]

Recently ive been using a 8 wrap 24g kanthal build. Forget what it ohms out to. Somewhere around .35 to .4.