Kayfun 3.1 needlefill broke off inside

[regal]

Is there anyway to salvage this?

[VapeHappy]

Do you mean the screw? Large KF?

Need to clarify. If its the screw I can show you a tool that will remove it.

Best,

Randall

[regal]

Its the port where you fill. Show me the tool please.

thanks

Edited August 23, 2014 by regal

[VapeHappy]

This is the tool I use to remove broken screws from watch movement plates, it should work on the KF deck but I`m not sure its cost effective considering the cost of the tool.

The two little serrated prongs in the middle between the arms, these get screwed down tight on to the broken screw nub, and then the whole plate (in this case your deck) is turned so that the screw comes out. These do come in a couple of sizes in case the throat shown here is too small. Sometimes they can be found cheap in the ebay watch tools section if you want to try there, brand new they are 150+.

Been watching you with your NET extraction (its chinese to me so far, LOL), so we could do a trade if you did`nt want to invest in the tool, :?)

Eitherway, best of luck, :?)

Cheers,

Randall

[fishguy1123]

On a KF 3.1 the fill port is a ball bearing of some sort. The idea is you press it in with your filling device and it springs back when you pull the device out to seal the port. I hope you can get it out, that would suck!

[VapeHappy]

Thanks Fishdude. Toomany kayfuns, LoL.

On the mini I got I just gave up on it and plugged it, and fill it from the top.

I dont beleive that design is good/fit for its intended purpose.

[regal]

I was able to pull the broke needle out, time to sell these kaylights I like RDA's much better.

[LOSTSOUL VAPORZ]

I messed up the fill hole on my first kayfun & it would have a slow leak! I got the bottom section with the fill hole on the side off of fast tech for my kayfun, like on the Russian for 12 bux. It took about 17 days to arrive tho! Lol good thing I have a second kayfun!