Just got first mech mod and rda! Questions

[jsiddlehfx]

So I just purchased a turtleship and Tobh v2 rda..

The guy at the shop built me a .6 ohm dual coil setup. 28 GA wire with 8 wraps each side.

My battery is the purple 18650, 30 a I believe...

What do I need to know about the battery? How do I know when to charge? How can I tell via the vape? What else do I need to know along safety?

[Compenstine]

What brand of battery?

30amp is ok for sub ohm, but some brand batteries are safer than others. Some give a 30amp rating by the company but are not good for sub ohm.

I would go with a Sony VTC 4 or 5

Best way I tell is when the Vapor production becomes less I will then do a voltage test. If it is 3.6v or close to that, I will charge it.

Make sure you get a multimeter or ohm tester. It is a must have when sub ohming even if a shop built your coil.

[jsiddlehfx]

It's actually a 35A batt, erest? some name like that... I work at an electronics shop so I can probably pick up a voltage and ohm tester

[Compenstine]

Efest is a good battery for APVs, but I have heard they can heat up with a sub ohm build. Keep a close eye on it. Take about 5-7 draws and check it, if i feels warm don't trust it.

[jsiddlehfx]

Ok...