jsr27 Posted August 1, 2014 Share Posted August 1, 2014 I'm gonna get a Kay fun lite. Am I going to be able to reach 2.0 ohms? I'm using a vamo v5 and is this a good rba to use with the vamo? If not what rba do you recommend that's rebuildable. Thanks Link to comment Share on other sites More sharing options...
mvince201 Posted August 1, 2014 Share Posted August 1, 2014 The kayfun will work fine with the vamo, and you should not have a problem reaching 2.0ohm with 28 or 30 gauge wire. Link to comment Share on other sites More sharing options...
jsr27 Posted August 1, 2014 Author Share Posted August 1, 2014 Will I be able to get 2 ohms with twisted 28 or 30 gauge kanthal? Link to comment Share on other sites More sharing options...
Bushwick Posted August 1, 2014 Share Posted August 1, 2014 Negative. Link to comment Share on other sites More sharing options...
mvince201 Posted August 1, 2014 Share Posted August 1, 2014 With single strand you can, but not with twisted. Link to comment Share on other sites More sharing options...
Monkeyman Posted August 3, 2014 Share Posted August 3, 2014 You seem dead set on 2.0 ohms. Why? I almost always vape with sub ohm coils (around .8) and rarely wrap higher than 1.5 (ish) coils. Less power means longer battery life and they heat up fast and stay hot. If you want a cooler vape, try a longer drip tip or something like CherryVapes Universal tip. Link to comment Share on other sites More sharing options...
regal Posted August 4, 2014 Share Posted August 4, 2014 He may have one of the new mods that don't really down regulate. The lowest they go is battery voltage squared divided by resistance. Link to comment Share on other sites More sharing options...
jsr27 Posted August 4, 2014 Author Share Posted August 4, 2014 I use a vamo v5 Link to comment Share on other sites More sharing options...
VapeHappy Posted August 4, 2014 Share Posted August 4, 2014 See if this works. http://www.steam-engine.org/coil.asp?si=false&r=2&id=3.0479999999999996 This is assuming you`ll be using a 1/8 in. drill bit like I do. I really would`nt worry about a couple of tenths in any direction until you know what does what. The Vamo cuts off at 1.3 or 1.2 ohms (depending on its sensitivity) so you can not go below that range. Cheers, Randall Compenstine 1 Link to comment Share on other sites More sharing options...
dave61 Posted August 5, 2014 Share Posted August 5, 2014 I use a Vamo V5 and a Kayfun My coil is 7 wraps of 32ga on a 5/64 drill bit gives 2.1ohms Works great on the Vamo 2.1 is the sweet spot for a vamo Flavor is good from 4watts all the way to 15watts you wont get humongous vapor but willk get fantastic taste Link to comment Share on other sites More sharing options...
Mr Smith Posted August 5, 2014 Share Posted August 5, 2014 (edited) I run 6.5wraps with 32g and come out to 1.6ohms. works perfect in my KFL+ and vamo V5. Ignore the wick..I was taste testing flavors and using it like a dripper with scrap pieces of cotton. I normally have more wick than that for a regular build so it doesn't flood. believe me when I say: you don't need 2.1ohm to get a nice vape from a kayfun. It's a completely different experience from a pre-built coil/tank setup.... the vape is much much cooler from a kayfun, the volume of vapor is at least 10x more than any regular tank, and the flavor is ridiculously strong. and if you wick it right (it will take some practice and learning to get it just right) it will never get a dry hit...you can chain vape it back to back 5+ times in a row without taking a break and it will keep right up with you without vapor getting hot. Edited August 5, 2014 by Mr Smith Link to comment Share on other sites More sharing options...
Bushwick Posted August 5, 2014 Share Posted August 5, 2014 Chase flavor, not clouds. Link to comment Share on other sites More sharing options...
MiamiDan Posted August 8, 2014 Share Posted August 8, 2014 Chase flavor, not clouds. +1 Link to comment Share on other sites More sharing options...
dave61 Posted August 8, 2014 Share Posted August 8, 2014 +2 The flavor cant be beat And there is enough vapor to satisfy most Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now