Jump to content

Vision spinner 2


Hunterj124

Recommended Posts

Check out the thread vision spinner 2 question. They seem to get stuck going from orange to blue etc... If unplugged and plugged back in they will usually finish chargeing.

Correct. Read that thread, I started it. I have 9 Spinner 2s and they are maybe the last battery I will use or try. It is a pause in the charging cycle. All of mine did it when I first got them but after 12-15 charges they started charging completely on an overnight charge. I just got 3 new ones and they pause between orange and blue like my others did at first. Personally I think they have power to the point it maxes out the abilities of the chargers.

Link to the thread:

Link to comment
Share on other sites

I read the thread but not really any help my problem is that I can try and charge it for two days and it won't glow blue or white when I use it and it only works about four to five times and it dies again

Edited by Hunterj124
Link to comment
Share on other sites

I read the thread but not really any help my problem is that I can try and charge it for two days and it won't glow blue or white when I use it and it only works about four to five times and it dies again

Sounds like you either have a dud or a charger not strong enough to do the trick. I got a couple chargers in a started kit that are generic and they will not charge my Spinner 2s but I have no problems with the JoyeTech chargers charging mine. It does take 5-6 hours to go from dead to fully charged but I usually just top them off at night and rarely run one all the way down anymore. Other than the occasional "reset" when they give a false green light that they are charged I havent had an issue like you are having.

It sounds like your issue is different than ours just though that might help. Are you using a wall adapter or trying to charge just with USB in a computer or something?

Edited by bcartervol98
Link to comment
Share on other sites

I'm using a USB charger

I personally will never charge a battery without the wall adapter. Not only is it way quicker it also adds a layer of protection against surges and other things that can have bad consequences. Just my 2 cents. WIthout a wall charger not sure I can give you any advice since there are so many variables. It could be a bad battery, bad charger, short in the wire, or any of a number of things.

Link to comment
Share on other sites

Thing is I don't have a credit or debit card to use to buy a good charger like you have

Its not a matter of having a good charger, its a matter of having one powerful enough to charge the Spinner 2

Link to comment
Share on other sites

All 8 of my Spinner 2s are still having a pause during the charging cycle where I have to unplug them then plug them back in. I'm glad to hear that yours finally got straight Carter, now I have hope for mine. It's just a little inconvenient. But since I got my Provari they have been packed up. I'm loving my Provari so much I don't think I will be pulling the Spinners out unless something happens to my Provari, knock on wood.

Link to comment
Share on other sites

Even when I unplug and plug it back up it still won't charge I take four to five puffs on it and it dies again it just won't charge I don't know if it's the charger the batter or both I don't know I just really need a new battery cause I feel horrible without nicotine I get anxious and cranky and tired and just feeling horrible if I don't have nicotine that day so in two weeks when I can get me another battery I'm buying me like two so I can have one fully charged all the time

Edited by Hunterj124
Link to comment
Share on other sites

Okay.

I would measure the output of my charger and make sure it is 420 ma

Or borrow another charger and try it out or put a different battery on the charger and see if it works. The spinner takes the exact same charger as any other ego style battery.

I would search and verify you have a genuine spinner. Where did you get it and how much did you pay?

If all above checks out then battery is defective and should be returned

Mike

Link to comment
Share on other sites

I have 3 Vision 2 Spinner's because I like them so much and they make them in great colors. Whenever I have to charge it I wait for it to turn green on the charger (which happens pretty quick) and then I unscrew it and screw it back in and then it will fully charge. It is a little bit of an inconvenience but I deal with it because I think it's a great product.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...

Important Information

Terms of Use Privacy Policy Guidelines