No vapor

[jlh 1741]

I built a 1.5 ohm coil on my tobh atty and im not getting any vapor production. I put in a new battery and am using organic cotton for a wick. Any suggestions?

[mvince201]

Wick too tight? Atty connections tight? Contacts clean?

[Joshuab3687]

Several things:

1st, what mod are you using?

2nd, what pg/vg ratio juice?

3rd, are you using stock airholes?

4th, a 1.5 build doesn't heat up as hot and/or fast as a lower ohm build will.

[jlh 1741]

Kamry 101. Vaping spacejam. Doesnt have a pg/vg listing on the side but produces nice vapor from my aerotank on same mod. New to building coils, any advice is appreciated.

[jlh 1741]

Stock air holes. 6. 3 on each side of tank.

[jlh 1741]

Wick could be too tight. Whats the best way to thread them through you coil?

[mvince201]

A picture would be pretty helpful. What gauge of wire are you using?

You want your cotton to be threaded through snug, but not tight. I like mine a little on the looser side if you know what I mean.

[crush02342002]

Check for heat comeing off coils, if no heat then check with a meter if your getting voltage to coils, if no voltage take atty off mode and check resistance at atty connection (any place on the bottom and on center pin). If this checks out ok then I suggest raising your pin on your mod, it may not be making contact with atty center pin. If this checks out check for voltage on mod. Firing button may have contact issues. I hope this helps some

[jlh 1741]

I got it. The pin on the bottom of the tank was screwed in to far. Backed it out a bit and wham! Clouds! Thanks to everyone for your help!