How does this work?

[Eaglewtchr]

A friend gave me a dripper and i can't really find any info about it. On the side of it it says, Smok Dripper RDA. My friend has it built already and my ohm meter says .51 but im not sure its setup right. Here's a couple pics..

Any info or advise?

[Tony8806]

Is that a coil wrapped around the post?! You could change it to a nano coil which is just a smaller coil, IF its not producing enough vapor or vaporizing the smoke in less than 2 seconds.

There's some pretty smart veteren vapors on here they should give you a better idea on your "problem".

[Eaglewtchr]

No, The coil leads go thru the posts. The wick is wrapped around the posts.

[Compenstine]

What battery are you using?

[Eaglewtchr]

VTC4 in a Nemesis clone. He already set it up and i checked it. It just has a clogged draw to to and not much vapor. I found "1" video review for it and the guy had the coil on the other side but used ecowool. I have some 1.8ish ecowool pre-made. Just not sure they will fit right. Might try those and see.

Edited June 3, 2014 by Eaglewtchr

[Joshuab3687]

Can you take a pic of the airhole? You may need to drill it a tad larger for increased flow

[Tony8806]

Stick to cotton. May need to open your airholes^

[Eaglewtchr]

It only has 1 air hole 2mm..

[Eaglewtchr]

I'm just trying to figure out how to set it up.

Should I use more cotton than I would on an RBA/RTA like the KFL+ Since it doesn't have a well to hold more juice?

Does it matter which side the coil goes on?

Can i run dual coil? I'm thinking i can't because it only has 1 air hole.

Thanks.

[mvince201]

1 air hole = 1 coil. The air hole must always be placed directly in front of the coil.