EvilSnipa Posted May 9, 2014 Share Posted May 9, 2014 I had a few old parts laying around the house and was wanting to use this board for a little mod.The problem is im having a brain fart on how i should wire this one, and was woundering if someone could give me a quick hand? Thanks for any help!! Link to comment Share on other sites More sharing options...
Compenstine Posted May 9, 2014 Share Posted May 9, 2014 I see XXXXnin V3.0 can you show the whole board please? And it looks like that board has seen better days looks like it is burned by the by the chip bottom center in that pic... Link to comment Share on other sites More sharing options...
EvilSnipa Posted May 9, 2014 Author Share Posted May 9, 2014 Yeah man thanks for the reply. I was going to toss it,but figured i could reuse it to make something simple.I dont plan on useing it as a everyday user. The problem is all but one wire got pulled off.It probably wont be too hard to figure it out but was playing the safe side and figured id ask you guys first.Here are pic's of the rest of the board. Link to comment Share on other sites More sharing options...
Compenstine Posted May 9, 2014 Share Posted May 9, 2014 I still can't read the name on the board. I was going to search for schematic for you, but need to know the brand name so I can do that. It is a long shot but most are set up the same way. You may be able to figure it out by looking at the EVOLV PDFs of their boards. Link to comment Share on other sites More sharing options...
Proetus Posted May 10, 2014 Share Posted May 10, 2014 Looks like it has on board adjustment buttons for it. Hot would be the positive to the atty, gnd would be the negative to the atty. no ideas on the one SW or Led. A switch requires to leads to function. Link to comment Share on other sites More sharing options...
EvilSnipa Posted May 10, 2014 Author Share Posted May 10, 2014 The name on the board is "esmoke_min v3.0" some things i do know about the board are It is only variable from 3.0 to 5.0 and it is a passthrough. I have looked online but could never find any info about this thing.Thanks for the help! Link to comment Share on other sites More sharing options...
saaaaam Posted March 3, 2016 Share Posted March 3, 2016 U1(replacement )=MCP73831/2 (Miniature Single-Cell, Fully Integrated Li-Ion, Li-Polymer Charge Management Controllers) U3=PIC16F722 U4=? U5=UT8205A Dual NFET 2x6A common Drain. U6=TPS63020-Q1 (TPS63020-Q1 High Efficiency Single Inductor Buck-Boost Converter With 4-A Switches) "U6" - Ez az IC állítja elő az "égető" feszültséget amit beállítasz! Q1(replacement )=LM6206N3 (Low Dropout CMOS Voltage Regulators) R6..R14 resistors (a D/A átalakítást végzik PIC B portján lévő 10K-k segítségével R/2R hoznak létre Digital/analóg átalakítót) 8205.pdf MCP73831T-2DCI_OT.pdf Ha van kérdés, kérdezzetek bátran Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now