samp1590 Posted March 27, 2014 Share Posted March 27, 2014 I have an itaste vv v.3 and a Kangertech mini protank 2 with a 1.8ohm coil in it. My itaste works fine with other tanks (like an iclear 16, and a standard ego tank). I've had my itaste for about a week now and have been using it with my mini protank 2 continually but today when i changed the tank to an ego model to try it out, it worked fine, then i put my mini protank back on the itaste and it reads "non" and wont fire. i need help, I've tried changing the coils to another kanger 2.2ohms coil but still no luck. I've looked online for solutions and I read something about "pulling the bar" but i have no idea what that means. i need to use my mini protank 2 again! PLEASE HELP! Link to comment Share on other sites More sharing options...
samp1590 Posted March 27, 2014 Author Share Posted March 27, 2014 Bare in mind both coils and the tank worked perfectly before I put the new tank on my Itaste Link to comment Share on other sites More sharing options...
dave61 Posted March 27, 2014 Share Posted March 27, 2014 You can try turning the battery off for 90 seconds to reset it I had the same problem and that worked for me Link to comment Share on other sites More sharing options...
Tam Posted March 27, 2014 Share Posted March 27, 2014 That's pulling the center pin of the battery connection. Mtdobies 1 Link to comment Share on other sites More sharing options...
samp1590 Posted March 27, 2014 Author Share Posted March 27, 2014 You can try turning the battery off for 90 seconds to reset it I had the same problem and that worked for me Thanks but still no luck That's pulling the center pin of the battery connection. I tried this but I cant seem to get the centre pin on my Itaste to move even a little Link to comment Share on other sites More sharing options...
Compenstine Posted March 27, 2014 Share Posted March 27, 2014 Make sure your coil is tightened down all the way into the base. samp1590 and guitardoc64 2 Link to comment Share on other sites More sharing options...
samp1590 Posted March 27, 2014 Author Share Posted March 27, 2014 Make sure your coil is tightened down all the way into the base. it's all good, after a while of tweaking about with it, i've sorted it out, thanks everyone Link to comment Share on other sites More sharing options...
fishguy1123 Posted March 27, 2014 Share Posted March 27, 2014 Would you mind shareing what you think it was and how you fixed it? I have the same setup and might help me incase I run into the issue in the future. Thanks samp1590 1 Link to comment Share on other sites More sharing options...
samp1590 Posted March 27, 2014 Author Share Posted March 27, 2014 Sure thing, its happened to me a few times only this time it was more of a pain to resolve. First i tried tweaking the battery up, or "pulling the centre pin" but my VV wasn't having any of it so it was a case of having the bottom of my tank attached to the VV and then screwing the coil on multiple times each time it got tighter and tighter and i don't quite know how, because it seemed like id already done the exact same thing about a hundred times but it eventually read it, going to get a Kanger Aerotank at the weekend because i have a feeling it'd work better having a different threading. But good luck, if it does happen to you, dont give up, it just takes a bit of playing around with. guitardoc64 1 Link to comment Share on other sites More sharing options...
fishguy1123 Posted March 27, 2014 Share Posted March 27, 2014 Thanks for the info and good luck with yours as well! samp1590 1 Link to comment Share on other sites More sharing options...
44shooter Posted March 28, 2014 Share Posted March 28, 2014 I am having a similar problem. I have 3 batteries and many tanks. my ego type cheapo tanks work fine on my ego/510 batteries. I also have a Protank 3 and a Drunker tank. If I attached either of those 2 tanks to the ego batteries, the light on the battery flashes, which I assume is a short. sometimes if I back the topper off a turn or so, it will fire. this adjustment is super critical. there is only a very fine line where the tank will fire. Go to far and it wont work again. I just tried pulling the battery pin up. didnt make any difference. Any ideas? Makes no sense to me. Link to comment Share on other sites More sharing options...
44shooter Posted March 28, 2014 Share Posted March 28, 2014 ok solution: pulled pin on topper out pretty far and carefully attached to battery. as long as I dont take it off, I'm good. When I pull the battery post up, the tank just pushes it back down. so I assume things arent always lining up. Cant wait for mod parts to get here and I wont have this problem. Thanks for the help! Link to comment Share on other sites More sharing options...
samp1590 Posted April 1, 2014 Author Share Posted April 1, 2014 UPDATE: ditched my Protank mini for a Protank 2 and I no longer have that problem, it works a treat! i think the itaste just doesn't like the protank mini. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now