Jump to content

Need help with my Elego Twist


Wolf3672

Recommended Posts

I repair ego batteries all the time for Central Iowa e cig stores in Des Moines, Iowa. Sounds like the positive post insulator [rubber gasket thing around the firepin inside the head] could be compromised causing a short. The next thing if it wasn't that is most likely a loose wire fom the circuit or the negative [black wire] in the bottom came loose from the bottom cap and needs soldered back on.

Link to comment
Share on other sites

I repair ego batteries all the time for Central Iowa e cig stores in Des Moines, Iowa. Sounds like the positive post insulator [rubber gasket thing around the firepin inside the head] could be compromised causing a short. The next thing if it wasn't that is most likely a loose wire fom the circuit or the negative [black wire] in the bottom came loose from the bottom cap and needs soldered back on.

Or...you know...it could just be a simple thing in that the center pin was pushed down too far and wasn't making a connection to the atomizer's center pin.

Just like we figured out about a page or so ago. :)

Link to comment
Share on other sites

  • 8 months later...

Hey I'm a newbie. I bought an Elego twist today and charged it for a bit with the charger that came with it but on an aftermarket usb plug for the car. The light won't go off on the twist and if I put something on it to vape its like Im holding the button down non-stop! I thought the battery would eventually die but apparently its a good one and no luck yet! It won't turn off either. When I charge it from my laptop, the charger blinks red slowly, not sure if this is normal. Ive been using a pass thru so this is new to me. Im afraid its going to overheat or something and I dont have time to go back to the vape shop today. Any help is greatly appreciated!

post-32741-0-91421100-1407526603_thumb.j

Link to comment
Share on other sites

The battery wont die until it has a load n it.

Did you try cycling it on and off with rapid button clicks? (Usually 3 or 5 rapid clicks).

Sounds like your bitton is faulty

Link to comment
Share on other sites

Yep, sounds like the button is faulty. I'd take it back to where you bought it and get a replacement. Just running the led won't be much of a "load" so it could run for many days keeping the "light on for you" :D

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...

Important Information

Terms of Use Privacy Policy Guidelines