My First Quad Coil

[Compenstine]

I received my Igo-W4 in my Vape mail today. After 2 hours of messing with it, I finale built my first quad coil.

Only had one issue while building this. The screwdriver slipped and crushed one of the coils. Dang butter fingers. LOL After replacing that coil it is running at 0.8 ohms.

Now I just need to wait for my cotton to dry and can give this bad boy a trial run.

[rcoe]

(Can't see you through the dog)

[rcoe]

(Can't see you through the dog)

Dadgum auto correct. FOG!

[Compenstine]

OMFG Cough-Cough I'm Cough-Cough Dieing Cough-Cough-BWWWaa-Cough-Cough Why Cough-cough Did I Cough do this Cough-Cough to my self...

[Jeffb]

That looks cool even though its gagging you to death

[Bebop]

Man its lit like a xmas tree!

Weather forecast - cloudy all day!

[rcoe]

3 qt tank to make sure it'll wick fast enough.

[Compenstine]

I hit it like I would before and inhaled... Big Error in judgement LOL *Tells self... Small short hits must remember small short hits LMAO

[rcoe]

All joking aside, looks like a great build. Nice work.

[Compenstine]

Thanks I'm happy with myself since I have only been building coils for two an half weeks now. I just mixed some 50/50 to see how that vapes in this. I'm normally use less VG but, I have to give it shot. I may need a Fog horn...LOL

Almost dead batt 50/50 mix

Edited November 2, 2013 by Compenstine

[Rixter]

Great job on the quad, dude! I've got coil-envy now!

[Compenstine]

Thanks Rixter Im sure you will find a way to get one set up for your self soon.

So far I like the IGO-W4. If it wasn't for your post I probably wouldn't have bought it. So thank you again for pointing them out. I think the air holes could be a little bigger but other than that, I'm very with it.

I didn't find any good vids on doing quad coils so I was basicly on my own. What I did was build 2 coils with one wire. I'll do one set tomorrow and post a pic. Doing it that way made it very easy to install two coils at once.

[Uma]

Right on! I've yet to experiment, I'm so in a rut.

[Compenstine]

If any one is interested, this is how I wrapped my coils. I used solder for this example because it was just easier to see. I used 32ga Kanthal for the working coils. Wrapping 2 coils like this made installing 4 coils a breeze.