Dna20 Mod Build

[Breaktru]

Look what just came in the mail. For Beta testing

[Breaktru]

The Wattage value is easy to read.

Getting ready for the build.............

I coiled a length of 28 gauge Kanthal A1 wire and clipped my output on to various points to achieve the resistance in the test.

Testing at 7 watts:
1.5 ohm - 3.6v
1.7 ohm - 3.5v
2.0 ohm - 3.7v
2.5 ohm - 4.2v
3.1 ohm - 4.6v
3.5 ohm - 4.9v
5.1 ohm - 6.0v
6.4 ohm - 6.7v

Testing at 20 watts:
1.5 ohm - 5.6v
1.9 ohm - 6.3v
2.3 ohm - 6.9v
2.5 ohm - 7.0v
2.7 ohm - 7.3v
3.0 ohm - 7.8v
3.5 ohm - 8.3v - This is the highest resistance that doesn't warn: "Check Atomizer"
3.6 ohm - "Check Atomizer"

[Breaktru]

I still have to mount the FIRE button and shorten the wiring before it is totally complete. It has a USB jack under the UP/DOWN buttons. Using a 15C Li-Po battery.

[Jeffb]

That box must have been difficult to work with. Not much room to work. Looks great.

[Breaktru]

[Christopher]

And off to the front page you go

[Breaktru]

The DNA20 has Mode Selections as follows:

* 5 clicks of the Fire button enters Locked Mode and 5 clicks to unlock.
With the module in Locked Mode:
* Holding the UP and Fire buttons simultaneously for several seconds and you access the Left Mode. Continue holding the buttons and you access Right Mode. This Flips the Screen 180 degrees.
* Holding the Down and Fire buttons simultaneously for several seconds accesses the Stealth Mode and Normal Mode. Stealth mode allows you to vape without the screen illuminated.

When idle, the board goes into Power saver mode after a few seconds where the screen dims to half bright and then a few seconds more extinguishes.