Jump to content

Recommended Posts

Posted

I was wondering as I would like to know how much better the taste and vapor production is with the highest volt mod and how much volts it is.

Posted

The flavor usually decreases with higher voltages- but it does depends on the juice and atty resistance. The benefit of higher voltage is that you don't have to pull on the pv as long- it gets the job done quicker. The hits can be warmer, more vapor and also more TH. You'd have to find your sweet spot to figure out what voltage is for you- but between 4.2-5v on an LR atty is pleasant IMO. Any higher and you should be using a SR atty and you might want more volts than 5v with SR. Again- it depends on your sweet spot.

Posted

I run my VV PT @ 5volts to get a few more days from a carboned up atty ,other than that it is no higher than 4 volts.

Posted

I've tried mods as high as 6 + volts and honestly it's over kill. You'll get a huge hit but at the loss of flavor and comfortability IMO.

The sweet spot for many is usually around 4-5 volts. Just enough to give that kick with out killing flavor, your atomizer or your mouth.

Posted

I run my VV PT @ 5volts to get a few more days from a carboned up atty ,other than that it is no higher than 4 volts.

Same for me.

I have used 6 V for a very, very short time....killer. I like the 4.7-5 range. I use 5V for a dying atty to get a few more days out of it.

Posted (edited)

I used to vape off my 12v car battery but I kept popping attys. :lol:

Edited by jeffb
Posted

I vaped at 6V for several months (would actually be about 5.2 - 5.4V under load). At a time when I couldn't get enough throat hit, it did the job. Now I'm down to using 4.1V - 4.4V mos to the time.

Posted

I got the VV OG Buzz to go to 8.7-9.3 on ElixirTV and it vaped, i was scared to since it is NOT suppose to be turned that high but we tried to see how high we could get her to go and she went way higher than 6V.. IMHO I think over 6V is non-since and is to much heat... i like 5.7 V myself...

Posted (edited)

I got the VV OG Buzz to go to 8.7-9.3 on ElixirTV and it vaped, i was scared to since it is NOT suppose to be turned that high but we tried to see how high we could get her to go and she went way higher than 6V.. IMHO I think over 6V is non-since and is to much heat... i like 5.7 V myself...

!!!!

My og buzz only goes to 6.3! 9.3 volts = POP

And i have to agree. I think even 6 volts is overkill. 4.3-5.2 is usually where I'm at.

sent from my Ice Cream Sandwiched Gtablet

Edited by bobthesalesclerk
Posted (edited)

well, it screwed up to 8+ I may be wrong about the 9+ but we did get it to register above 8 but l but I pushed that button for about 1 second was not sure of the dangers of it but we were on the air (did not want to have someone else try it at home and have something go wrong i would have fealt bad for them and the manufacturer for doing something outside of there suggestions with 50-100 people watching ya know) and checking the highest the meter said it would go, not something any normal atty would withstand, and safety or not his manual said 6V max so going past that I would assume would not make it safe anymore, but we still put it to the test.

Edited by kwaione
Posted

110 volts, AC...

I dripped onto my toaster once. The vapor was good but the flavor was awful. I don't recomend it. :laughing:

Posted

I almost forgot about my 400,000 volt stun gun mod. Needless to say this didn't work either. :rolleyes:

Posted

5v 808 passthru is the highest I've ever gone and probly will ever go.I'm either vaping that or one of my 3.7v LEO's or 808's. The v/t/f is perfect for me at those voltages, I honestly have no reason or desire to go bigger, faster, better like most.....

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...

Important Information

Terms of Use Privacy Policy Guidelines