Map Tank Burnt

[defiassp]

So i purchased a 3.2 ohm MAP tank off of COV and for starters my provari is only registering 2.7 ohm which i am pissed about and now my wick is frikken burnt and everything i vape tastes like burnt dog hair or something..anyway i can jst put a new wick in or pull it to one side?

[Jeffb]

If your carto is burnt, there is nothing you can do. Gonna have to put a new carto in it.

[CASEACE79]

I did this too on my second carto. Nothing ya can do about it. What I do after filling the tank in draw on it without firing and you'll see bubbles coming out of the punched holes. The air is getting replaced by liquid. I do this for a couple min then I top it off with a couple drops. Haven't had a problem since.

[Brian]

You have a CE2 tank? I found the CE2s to be somewhat inconsistent. I had a few that just burned very hot no matter what I did. The ohms would check out correctly, but it would just be very hot and burn my juice even when I turned the voltage way down. Also, IMO, some of them just don't wick well. Fortunately, I had a tank that I could just turn upside down for a second and it would saturate the coil.

[CASEACE79]

You're right Brian. I just assumed we were talking about a DCT. My post above only works with a DCT MAP tank.