shen_long86

You are a good man jason.

http://imgur.com/PCG21ZG Got a 30 ml bottle of #113 of Odin by BW it is 70% v.g. juice, it is an interesting juice that changes flavors the higher you go in power... cant really describe the taste but it is good. also got a 25 ft. roll of 26 ga kanthal to hopefully build coils a little bit easier.

Thx Earthling for the advice and help...lol sorry you cant have...its my precious!!...lol

Oh yea jason...they also built a new dual coil setup at 0.45 with 26ga and it works great

Yup earthling it was the batts they were junk...got 2 mxjo 26650 imr's 3500 mah and it chucks like it should now...and the guys at the shop were jealous that i got this mod for a steal.

Congratulations fishguy!

Push down on it with a flathead screw driver...if it pops back up when you let go it is spring loaded.

Thats a sweet setup there Rixter

Yea earthling that is what i am leaning towards as well...i will find out later when i take it up to my b&m to have them check the batts. I think that they may have been bad when the other guy bought them originally.

That is my same thoughts jason...but i did clean it last night and let it air dry...just reassembled and adjusted and it hits a little bit harder but not much...even with a new 0.6 ohm build on the deck.

Jake i did the adjustment so there isnt any battery rattle and i did adjust the 510 pin to for my rda...and it still wasnt working properly.

Will do

Gotcha thx earthling will go and clean it and let it air dry over night and test it again tomorrow. Before i head to my b&m, also going to try another build...probably around 0.5 and see if that helps as well.

How should i clean it?...vodka soak, plain water?

I tried all adjustments i could think of...eg 510/battery screw, and the pin on the fire switch...still no improvement. I am going to take it all to local b&m tomorrow and have them check it all.

No i usually run my ipv between 21 and 25 watts...and i get more vapor off that than my mech

Dont have a volt meter...by barely works i mean i put it in the mod and get very little vapor production...and both my rda's are running dual 0.8 ohm builds that work fine on my ipv mini

26650 cartel copper clone mod and limited edition cartel copper rda clone.

hey guys i just got my 26650 cartel copper mech mod and i got 2 mnke 26650 imr batteries with it and an nitecore intellicharger i2. my question is how long do these batts usually take to charge? i put the batteries in the charger at 1 pm, so it has been about 5 1/2 hrs since i put them on charge and all 3 lights have stopped blinking and are solid yellow. does this mean that they are only half way charged? i did test one after the lights stopped flashing but it barely worked, so i am assuming they are not fully charged. i apologize guys this is my very first mech mod and i am not used to having to charge batts this way, this is the only reason why i am asking... -thx drake

Hahaha

Sweet thx for the tip guys i will have to start storing my juice in my mini fridge here on the truck.

Lol @ Rixter...that aint right...lol

Sweet rda....now i want one

Sweet tug

I got 2 rda's with the mod... limited edition cartel copper rda and an omega plume viel clone.