Spyke_696

So I started out vaping 24 mg got into diy and mixed 24 mg and went hmmmm so i downed it to 18 all was good kept vaping that....then went hmm and down to 12mg then to 10 mg then this past week went to 5mg and soon 4 then 3 then 2 then 1 then none and just vaping to enjoy a hobbie i love with out the bind of nic ...it wasn't why i started vaping bit i must say it will be cool to know I'm not bound by a nic fix

note: this i think can only be made in a mephisto as big wire is used

ok so im setting here looking at my box of wire and went im gunna go crazy and build somthing i have never seen before and see how it goes and damnnnnn it hits hard most of you may see this and go wtf hell i did but try it if you wish it gives mass flavor and a huge cloud i meen huge so here it is heres what i cam up with

i wrapped 2 micro coild one in 20 gauge and the other in 22 gague and a 3rd coil in 28 gague but its a super super small wrap dunno what that would be called.... so i put the 20 gague coil in one side facing one open end to the air hole and on the other side i put the 22 gague coil facing vert as close to the air hole as possable now the 28 gague super small wrap get twisted inside the org cotton wick and fed thru the vert 22 gague wire the cotton is so you dont short out and for wicking

she should be at .13 ohms posting pics in a little

sounds like a crazy build maybe stupid but thats why im calling it the Heretic Coil

wicking wrap org cotton around the 20 gague coil none going thru the center and wrap a small amount around the 22 gague as well if you want wont be needed sence you got the one running thru the center but i did it for added juice sence its a lower ohm build

My neme and clone neme side by side again clone is h cigar the only difference is the engraving on the h cigar isn't as deep other than that everything is the same even performance

well i got the tobh you said about cant wait to get it on on youtube as im typing this looking into it and im thinking im glad i went with this rda so ty steeze and ty mtd for your input but i went with the tobh maybe after using it ill be ok with drilling or for me being a aftermarket car mechanic ill mechine it like i do with the engine heads but till i figure out whai i need im not doing so but agin im going with that ty again my neme will enjoy it like i will i think (if anything was messed up note rum drunk wile posting :p )

There are calculators online to do these things for you but I would rather learn the simple equations and actually understand what is going on. Like you said its your face at risk...

My buddy took months to talk me into anything past a blu.

Just take it easy and don't listen to what everyone says. Not everyone in this hobby is well rounded. Im not saying on this forum, but in general. Make sure you are sure, not someone telling you about it.