mvince201

I'm loyal to my tobh usually. But I vape. .1-.2 daily so air flow control is not necessary

IMO the Russian 91% is the way to go. I have the lite 3.1 and the Russian has better airflow and just seems more solid to me.

Welcome! Enjoy your stay, checkout is at 11 a.m. and breakfast is served at 7 a.m.

I want one of those soooo bad.

Lol weird. I went from 12 in a pro-tank to 6 in a dripper and doesn't bother me a bit. Normally a vape a 3 or 4mg but thats just do to the harshness when sub-ohming.

If you are building coils, why not look into a kayfun, or some other rebuildable atomizer rather than a pro-tank which is not meant to be rebuilt?

The only way I can think of to get more vapor out of that setup is moving to a 1.5ohm coil head, and even then the difference will be minimal. Rebuilding the kanger coil heads with cotton allows for more vapor and flavor, but in that case you would be better off just moving to a Kayfun or the like. I personally think the nautilus puts out more vapor than the aero-tank, but again the difference is minimal IMO. Hope this helps, and welcome!

I went from a 12 to 6 when I started chasing and never had that problem. It's possible that it could be a flavoring in the juice that your body doesnt agree with. There are a few juices out there that make me nauseous just from the type of ingrediants they use. It is probably the nicotine in your case, just throwing it out there.

I had to. Lol.

Welcome!

I believe they can be set up either way with either battery.

Sleepers hold a better connection and prevent uneven heating with a 3-post setup. It's just that simple.

WWW.steam-engine.net

I've always built my brass monkey that way. I always run the positive to the far side to center the coils better.

24g tri-parallel sleeper, now thats a real trick :P

Simple fact is, the government will do what the government wants. You just have to find your way around it.

Yes. One micro will have one extra wrap because you have to bring the lead around to go into your post hole. Or half wrap I guess.

Fantastic. Flavor is incredible.

Tricro FTW!

This is a 7 wrap 32 gauge coil on 1.4mm screw driver. Ohms at 2.3. This is what your coils should look like.

I use 24 and below. I've been liking 22 most.

I've found that positioning the coil barely above the air hole works best.

Thats the same thing I used. I used two different kinds of mustard. Used a paint brush to put it on and swirl it. Comes out really nice. Yours is looking pretty cool so far!

I believe I used 30g when I rebuilt my pro-tanks. With thicker gauge wire you will need more wraps to get to a higher resistance, not less. For example: 28g kanthal takes about 20 wraps to get to 3 ohms on a 5/64 diameter whereas 32g would take about 8 wraps. I believe you are using the correct wire for what you are doing.

Sweet! What are you using? Just salt and ammonia?