dave61

I just got in the mail today a Segelei 100watt plus
The mod so far seems great
The only problem i see with it is the screen is upside down when I hold it in my right hand
I cant figure how to change it even if it can be changed
 
 
 

I use peaches and cream cotton yarn from walmart
3 strands in a coil wrapped on 1/16 in drill bit with 7 wraps of 32ga gives me 2.1 on a V5 Vamo
Lay it on the ledge then asemble dont block the chanels
The wick I have in now is 5 days old and flavor still great
Ive been running this experiment to see how long the wick lasts before the flavor goes bad
so far so good

From the sound of it you went at it the wrong way
You didnt say what tank the coil was in

so the directions i give are for kanger pro tank 2

Dont unwind the coil
Just wet the wick and with tweezers pull the wick out carefully without moving the coil

pull a small piece of cotton off the q tip and roll it between your fingers

Make a point on the end of your cotton
insert inside the coil
Try your best not to push the coil to one side or the other

Trim the cotton wick to size
Wet new cotton wick with juice
pull another small piece of cotton and roll between fingers
put on top of coil in slot so ends come out on both sides

Put top tube back in

screw base back on full tank

Let sit for 10 to 15 minutes so cotton wick can start wicking juice
Then try it

It would be best if you had an ohms meter to check the coil


Maybe someone here has a better way to do it and they will post

Othe rthan this you will need kanthal wire to build another coil
Im sure when you unwound the original it wont work right for you

I'm in SE kansas about 20 minutes from bartlrsville. I don't see many vapers around here. Glad were multiplying :-).