Rixter

I'll take that action. Who's got 'em for $25?

From rainbowheaventec.com: Product Description RainbowHeaven latest Hybrid mod ELITE V2 Main Features: 1: Updated genesis hybrid mod, 2: Made by stainless steel #304, the button made by brass to ensure a good electrical contact. 3: The clear tank made by quartz glass, with 5ml capacity. 4: Not only a hybrid mod, but also a telescope mod. 5: Work with 1pc 18500, or 1pc 18650 or 1pc 18350. Each Hybrid mod Elite V2 packed by a gift box, with 1pc ELITE v2 mod, 1pc drip tip, 1pc cloth pouch, 1m kanthal wire A-1, 1pc ss mesh, 1pc screwdriver. MSRP=$80.0/pc, retailers must follow the MSRP, we will stop supply for retailers fail to comply the MSRP. RainbowHeaven refuse any co-ops (group buying) order, sorry for the inconvenience and appreciate for your understanding. BLACKLIST: (RainbowHeaven wont offer hybrid Elite to the following web:) http://www.vaportekusa.com/product_p/elite-hybrid-.htm http://www.whitestagvapor.com/silver-hybrid-mod-elite-pre-order/ Material: main body and atomizer are made by stainless steel #304 and #303, button made by brass, the clear tank made by quartz glass. Each ELITE V2 will come with a cloth pouch, 1m kanthal wire A-A, 1 sheet SS mesh 400(30X50mm), packed by a gift box(craft paper) Atomizer capaity: 5ml. Recommended atomizer resistance: 1.5~1.8ohm. WARNING: 1: PLEASE DO REMOVE BATTERY WHEN YOU FIXING THE MESH COIL; 2: QUARTZ GLASS TANK IS RIGID AND FRAGILE, RAINBOWHEAVEN WILL PACK IT VERY CAREFULLY BEFORE SHIPPING, PLEASE BE MORE CAREFUL WHEN FIXING OR USING IT. THERE IS NO WARRANTY FOR QUARTZ GLASS TANK. RainbowHeaven refuse any group buying but only offer to retailers, sorry for any inconvenience and appreciate for your understanding.

Who's currently selling the V2?

Here's a little additional information from Vaping Mad: The AGA T3 atomizer is the latest development in genesis style atomizers. Brought to you by the makers of the VM Zombie, VM Shot, VM AGI and VM AGT, however this is a completely different set-up to the usual. Instead of running your wick on the outside of the top deck, the AGA T3 atomizer is set up so you run it down a centre tube. A nifty sleeve covers this tube with wicking holes that are large enough to constantly feed your wick. The AGA T3 atomizer also sees a new reduced top cap size with 'can't go wrong' air hole placements. 'Bout time gennys shrunk in length! The design ingenuity doesn't stop there though. Rather than using nuts to screw down your positive wire, the designers have instead created 2 centre pole slits with a tightening ring. This allows you to easily loosen, thread and tighten. No more fiddling with tiny screws and losing them in your shag pile carpet. The AGA T3 atomizer will blow you away with it's design and outstanding performance. It truly is a game changer! AGA T3 atomizer SPECS: - High Grade Stainless Steel construction - Pyrex tank - 1.5ml-2.0ml liquid tank capacity - 3.5mm wick hole, Insulated (suitable for all types of wick materials) - 1.5mm airhole - W=22mm, L=46.5mm - Spare Parts kit included Manufactured by: Youde Tech

Here's Youde's latest take on rebuildable atomizers. It's an RBA that wicks from the center as opposed to one side, and from what I can tell from the online pics, it looks like it's going to be really easy to coil. I haven't done a whole lot of research yet on who has the best deal on the AGA-T3, but I did find a limited number of them available at Discount Vapers for $49.50 ($52.43 shipped).

Great job on the quad, dude! I've got coil-envy now!

That's scary.

I'm still using my first (and only) HH.357 Long Barrel Hybrid 510 (2Ω SS), which I bought on July 20, 2013. It's still amazes me after over three months of use.

Please include a link because my Sigelei Kick only has a range of between 5-10 watts and is marked around the adjustment pot in half watt increments. I know that the newest version of eVolv's Kick (the original maker of the Kick) goes to 15 watts, but it's considerably more expensive than the Sigelei (like three times the amount). The rattlesnake noise that you're hearing is normal...it's the PWM (pulse width modulation) of the Kick's circuitry turning the power off and on rapidly to achieve your desired power level. Instruction to operate Kick from Sigelei: 1. How to set Power Level (watts setting): The adjustment potentiometer (blue box) is located on the top side of the Kick. In the center of the box is a white adjustment screw to be used for adjusting the Kick’s power setting. The watts settings are marked ON THE CIRCUIT BOARD and can be seen around the pot/blue-box. NOTE: there are lines underneath each setting number, follow the lines to the corresponding watts setting. Turning the adjustment screw clockwise increases power and counter-clockwise decreases power. The settings range is from 5 watts to 10 watts. The Kick performs best with attys/cartos rated between 1.3 to 3.0 Ohms. You can use higher rated resistance but the Kick will not regulate well at the highest power levels if resistance is above 3 ohms. Unlike Variable voltage devices, the Kick does not need frequent adjustments. Once you find your preferred Power level, there is no need to constantly adjust it because the Kick will maintain that Power level even if you change attys/cartos and/or resistance. 2. Low Battery Indicator: The Kick will detect, and stop functioning, when a battery charge level drops below 3.2 volts UNDER LOAD (with an atty/carto attached). This is a safety feature. The Kick will tell you this feature is activating when you experience STUTTER VAPE (vapor-no vapor alternating – may feel like tss-tss-tss). If you continue to vape beyond this indicator, the Kick will stop functioning until a fresh battery charge is detected. Here's a close-up pic of one of my Sigelei Kicks. Notice the setting diagram to the left of the center post. Also notice the two dots on either side of one section of the white phillips head adjustment pot screw...those dots indicate the pointer (this Kick is currently set to 8 watts).

That's what I do...Scotch tape over the markings.

I may make the IGO-W4 my first RDA if they still have any in stock this weekend.

BTW...dual-coil possible = quad-coil probable in my book. This is not mine...I found this image on Google.

Triangle Vape has 'em for $20.10 shipped.

Here's the newest RDA from Youde. It looks like someone finally got smart and decided to make an RDA with a contoured cap that should be easier to remove.It's dual-coil, too. It seems they're a little hard to come by now (out of stock most places), but I found one on eBay for $24.99 shipped. Click here for the skinny.

Maybe the powers that be will come up with a glass replacement tank with a threaded metal ring on top, or an aftermarket SS tank.

I just got a Kanger Protank II, and I gotta say that I'm a little disappointed with it. There's nothing really wrong with it, but I somehow got it in my head that since the top comes off, I could fill my new Protank II through the top without having to remove it from my mod. Wrong. It still has to be filled from the bottom. The whole reason I bought it was to avoid having to keep removing it daily to fill it. Oh well...live and learn. Does anyone make a BCC glassomizer that you fill from the top? *EDIT* The Kanger Unitank fills from the top, but it's got a plastic tank, and I'm not sure if there's a glass replacement tank for it available.

Ugh! Where's the "Dislike This" button?

Good job. Glad to see a little MacGyver ingenuity in the vaping world.

Oh yeah...I almost forgot. It's also beard-growing season. Headed to the woods selfie

I got my first gun (besides the obligatory Red Ryder BB gun) when I was twelve...the 410 breech-loading shotgun that my dad got when he was a kid. Now I hunt with a H&R 1871 Buffalo Classic .45-70 Gov't. single-shot breech-loader. It's considered a primitive weapon so I don't have to switch guns during primitive weapon seasons.

I'm particularly fond of venison summer sausage, myself.

Well, it's getting close to that time of year again. Yup...deer season is about to begin and I, for one, have been waiting with bated breath all year for it. And speaking of bated breath, I've been wondering about "baited" breath. Specifically, I'm wondering if there might be a particular flavor of eJuice that might serve as an attractant for deer or a cover-scent for me, like maybe a peanut butter or apple flavored eJuice that may bring 'em on in. As far as giving myself away with "smoke" signals, I tend to hunt from a blind, so the visible vapor shouldn't alert them to my position. Is that RY4 I smell?

How'd the surgery go?

I can't seem to make it through a whole day without a little Pluid or Rixter's Absinthe. I'm getting hooked on the licorice flavored juices myself.

You mean to tell me that vaping crab legs in drawn butter or roast chicken sounds gross to you? Weirdo.