Leaderboard

Ask and ye shall receive

I bet I have built close to 100 builds on the SubTank Mini RDA. I can tell you from experience that te best wicking possible you want it so tight you think it is going to screw up your coil. In fact sometimes it does and I have to do a lot of adjusting after it is wicked. Another tip is to trim your tails so that they just barely touch the deck. You want them to fan out but not to cover the holes. Here is a picture I took from one of the other forums (not my picture). The general concensus over there is the best coil size is in the 2.5mm range and to stuff as much as 6mm wide of Japenese cotton only removing one of the covering layers from one side. I have gone back to using rayon and may post a picture tonight if I get a chance to rebuild. By the way, I run 1.5 ohms and 70pg/30vg juice @ 20 watts on the middle air holes. I do not take extremely long draws, but not short either.