Leaderboard

The newer Smok devices are providing pretty good TC. Have you found a power setting you like in power mode? What I mean by that is a power setting that gives you a good ramp up time and satisfying beginning of the vape. I would start with that setting in TC mode for the wattage setting. Every mod is different but in general the power setting in TC mode should provide 1. The maximum power applied during a vape. You will want to have the setting high enough for the coil to reach your set temperature. 2. Be a function of how fast your coils heat up. In mods that do TC well you will be able to set the power higher than the power to achieve your set temperature and decrease your ramp up time. 3. Some mods with a preheat setting will further boost or decrease the initial power to modify the beginning of the "hit". I hope that makes sense.

You need to know that the burning point of cotton is around 430' Fahrenheit so you wanna be below that. Wattage shouldn't matter as your mod should throttle the power to regulate the temperature but too low a power will make the coil take longer to hit peak temperature. I can't give a better understanding than that myself as I've only tinkered with temp control but that would be the basics.

I have a pair of them from when I worked for Boeing. I haven't used them for vaping wire, but they did the trick for safety wire on electrical connector backshells.

WISMEC has just released the new Predator 228 with Elabo Kit, any thought about this new device? Parameters Elabo Atomizer Size: 52.8mm *25mm Capacity: 4.9ml (Triple 0.2ohm Head); 4.6ml (NS Triple 0.25ohm Head) PREDATOR 228 Size: 43.6mm*29mm*86.7mm Thread Type: 510 spring loaded thread Cell type: High-rate 18650 cell Output Mode: VW/TC-Ni/TC-Ti/TCSS/TCR Mode Output Wattage: 1-228W Resistance Range: 0.05-1.5ohm(TC mode); 0.1-3.5ohm(VW mode) Temperature Range: 100-315°C/200-600°F (TC modes) Maximum Charging Current: 2A Maximum Output Current: 50A Output Voltage Range: 0.5-9V