I just received a Templar AIO kit by Vapor Talk in the mail yesterday. Since setting it up I have been vaping on it exclusively. Here are my first impressions.
Packaging: Very nice box art. It is definitely representative of the Vapor Talk brand. If I hadn’t already seen photos of the device I would have been tearing into the box in anticipation of checking out the contents. Instead, I tore into the box in anticipation of actually getting my hands on what was inside.
The contents: It’s no frills. You get the mod, 2 coils, the standard USB charging cable and a manual that is easier to understand than most I have seen.
The mod: Very simple to set up and operate. The hinged cover for the charging port (located on the bottom of the device) easily swings out of the way and has a magnet to keep it in place when the cover is in the ‘closed’ position. The top comes off easily, even with the child proof design. I had no trouble screwing a coil on and filling the reservoir/tank couldn’t have been simpler. The appearance is sleek, fits well in my hand and appears to be constructed well.
There do appear to be a couple of minor differences and/or omissions between the manual and the device. The manual says the charging light will flash 4 times to indicate a successful connection. I connected the device to 6 different ports with two different charging cables and each time I got a solid red light. This was after the initial “charging” because the fact the light didn’t flash 4 times was actually brought to my attention after the fact. The device also must have been mostly charged because the charging light went from red to green in a matter of minutes.
The other omission I noticed from the manual is the battery mAh rating. It isn’t listed in the manual but is listed on the VT website – 1000 mAh.
Operation: Charge it, 5 clicks to turn on, press the fire button, inhale and enjoy. It doesn’t get much simpler than that.
Experience: Overall it will serve as a very capable backup for me. I have been using it exclusively for close to 24 hours as of this writing and other than the fact that I might need to step up the nicotine it has served its purpose. I normally vape 3mg between .1 and .2 ohms, so going to .5 ohm just isn’t giving me the same “hit” I’m used to.
I have done everything from short 1-2 second drags to longer 8-10 second drags. Casual hits every few minutes to chain vaping. The tank does get warm when chain vaping.
I will admit that I was actually hoping it would serve as a nice little stealth vaping device, but with .5 ohm coils and the way I do DTL hits, that just isn’t going to happen for me. It might be a little stealthier if I up my PG, as the juice I have in it right now is a 10/90 PG/VG ratio, but even if I switch to a 50/50 or even a 60/40 I think I’m going to be producing quite a bit of vapor simply based on the way I vape.
The airflow does not appear to be adjustable. That’s fine and doesn’t take away from the operation of the device; it’s just tighter than my personal preference.
Appears to vaporize the liquid and utilize the battery very efficiently. I am still on the original 2ml of liquid I put in the tank, though I’m definitely getting toward the bottom end of that. By comparison, I would have easily gone through 6-9ml of liquid with one of my normal setups with the amount of vaping I have done and I would have easily drained 2 2500 mAh batteries, though I have no idea how close to drained the battery is. At 1000 mAh I would have though I'd have had to charge it a couple of times by now, but I'm still on the original charge.