Leaderboard

I have been rebuilding the horizontal occ coils, for some time now. Does anyone else here do that also? At first I was using coils with a 2.5mm id but was getting a lot of dry hits because of poor wicking, I changed to a 3mm id coil, and it helped a lot, but still a few dry hits. The holes in the side of the coil are 2.9mm, I was considering drilling them out to 1/8 inch which is 3.18mm to help juice flow. Not sure if that would help. The SS316L coils I use come out between .9 and 1 ohm. Any thoughts on the subject would be appreciated.