Leaderboard

0.32 mm is 28 gauge 0.40 mm is 26 gauge a 5/4 wrap on 3mm gives me a 0.5 ohm coil, works really good in my Kanger RBA heads.

You will like SS 316L wire, I have been using it a little over a week now. Its a little softer than Kanthal, but not near as soft as Ni200 its very easy to work with. The only time I dry burn it is when I build a new coil, and then just long enough so it quits smoking, not red hot. The nice thing about SS 316L is you can use it for TC and also dry burn if you want, Ni and Ti should not be dry burned. I only have 28g SS 316L and really like it, easy to work with and no taste. I may start using it exclusively.

This is a great calculator for almost everything vaping....http://www.steam-engine.org/juice.asp

Late to the party, but when I have juice that's too thick, I fill tank almost full, add a couple of drops of distilled water and shake to mix. That way I don't screw up the whole bottle and it thins the juice just a bit. Add more juice or more water as needed.

I hope you have luck kicking the stinkies habit, vaping did it for me. You would have been better off with a regulated mod rather than a mechanical like you have, but with the savings by quitting cigarettes you should be able to get one before very long.

That is a lot of PG. I've noticed how much better my throat feels after switching to high VG liquids. I prefer a 20 PG/80 VG ratio otherwise my throat is raw every morning, and I still have many 50/50 blends to vape.