Leaderboard

I received this device from our friends at Gearbest.com to review. I Have Been using this device for a week straight now and i have had zero issues with it at all. Specs: Size: 22.20*38.20*82.00mm Output Mode: VT-Ti/VT-Ni/VW/Bypass Mode Output Wattage: 1-60W Resistance Range: 0.05-1.0ohm for VT mode Resistance Range: 0.1-3.5ohm for VW/ Bypass mode Temperature Range: 100-315℃/ 200-600°F I have used every mode on this device except for Titanium mode, they all perform excellent with no issues. This device is a very solid performer all around and is by no means cheaply made, it is very sturdy (i.e. i have dropped it a few times because im a klutz.) Pros: solid performance - temp control Ni and Ti modes - firmware upgradeable - has a bypass mode (i.e. works like a mech mod.) - great beginner tc mod imo. - able to lock resistance Cons - the only realy issue i have found with this device is that the resistance bounces around a little bit even when locked in. but this is a subjective con in my opinion.

Since Blucavvy got the thread going in "Bump when you buy something new", I thought it would be good to get a thread going on what we receive in vape mail. I'll start here. Just got three of the four custom HH.357 hybrid spec atomizers I sent back to Hanna to clean/repair. The fourth was beyond help so it was discarded. They're just like brand new again! On Monday I'll be shipping out two more of these for similar treatment. I probably wouldn't need to do this but I insist on using the dark, sweet juices so they gunk up faster and don't clean out as well. Great customer service has Avid Vaper. So, what did you get in YOUR vapemail today?

When you go down to sub-ohm, the vape is warmer, and IMO, harsh. Nicotine is absorbed faster as it gets hotter, so you MUST lower your nicotine by 50-75% when you drop to the lower Ohm coils. For you to move from 1.5 to 0.5, that's a 67% drop, so I'd lower nicotine by at least that much, if not 75% (go to 0-Nic or cut your juice to 1.5 Nicotine)!! You'll also want to change your juice ratio to higher VG content... 50/50 mixes are a good option, and the Kanger coils can handle 30/70 PG/VG without much problems or dry hits. The only way you'll know if you like sub-ohm is to try it, but be aware of the Nicotine and VG requirements, as well as the fact that sub-ohming burn juice faster, hotter, and will deplete your battery faster, too.

Actually I think that is a step backwards. Mine (V1) just has the one big slot. The V2 has 2 smaller slots. From what I hear the V2 has better airflow. (If you are into that) I have been toying with the idea of getting the V2 base for mine, but I don't use my mini's anymore, except for backup.

The V1 tank and the V2 tank are nearly identical. The main difference is the RBA section and the airflow section. The one on the left is a V1. It has 1 large airflow hole. The one on the right has 2 smaller holes, one on each side. The one on the left is the RBA section from the V2. It has large holes on the sides to allow for juice flow. The V1 on the right only has the 2 small holes in the base to allow for juice flow. The 2 coils on the left are factory replacement coils, the right is the RBA.

Got it. Well I can see this is going to be a productive thread lol

I have one but I don't want a warning lmao