Jump to content

Leaderboard

Popular Content

Showing content with the highest reputation on 10/12/2015 in all areas

  1. Jeffb

    Walking Dead Fans.....

    Awesome start to the season!!
    1 point
  2. jasonculp

    Cthulhu RTA v2

    Here is my review of the Cthulhu RTA v2. This is how it came in. Pretty good packaging with an extra Delrin drip tip, frosted glass, and tools/o-rings. This is the tank section. L to R: drip tip, top fill cap, top cap, glass, bottom/chimney. It can be disassembled nearly completely for cleaning. The tank section assembled. This is the top of the build decks. It comes with both single coil, and dual coil decks. This is the bottom of the build decks. The one on the left is the dual coil, and if the pictures were clearer, you can see it has very large airflow. The single coil has 4 smaller holes, that lead up to the hole below the coil. It is a bit more restricted than the dual coil deck This is the base section. The piece on the left is the airflow control and the positive pin. It is adjustible and the system works very good. The middle piece is the juice control. The ring to the right is what you turn to move the ring up and down. It could us a bit more knurling, it is pretty slick. This is the base section and the build deck assembled. This has the juice control fully open (see the nearly invisible arrow). As you twist the ring the juice control moves up to contact the bottom of the tank to stop the flow of juice. Here the juice control is closed. Here it is coiled, and wicked poorly, but ready to go. Notice the ring to hold the wicks in place. This allows you to assemble and disassemble the tank without messing up the wicks. It is a great idea, but a bit hard to get on and off. So far it has been leak free for me and seems to wick very well. I am running a 3mm 28ga Ni200 coil on it at .16 ohms. Ready to vape on my Joyetech eVic VTC Mini. So far they have been a really good team. I really like this tank. It has a lot of pieces. It is not a simple tank. The machine work is not perfect on it, but it works well. I don't use the juice control, I just leave it wide open. I have only tested the dual coil deck, and it seems to work good. The single coil deck works great. It is a lot like a larger SubTank Mini deck. I have been running it in temp control mode for 2 weeks and have not had a minutes trouble. My coil looked terrible after 2 weeks, but I think this is more of a fault of the eVic mini, not the tank. It seems like the temp control is not working really accurate with the mini. I have to run it hotter than my other TC mods to get the same vape, but there are times where it seems to get too hot. I have it updated to the latest firmware, but it looks like they need another update. Overall I really like this tank. It is my all day every day tank at the moment. It has good flavor, and good airflow. The only downsides to this tank (at least mine) is the poor machining and the complex design. The machining doesn't bother me on any part but the top fill. It is a bit hard to get on and off. All of the separate pieces gives quite a few points of failure, but so far none have.
    1 point
  3. shen_long86

    Cthulhu RTA v2

    Great review jason!...i like that design for the dual coil deck.
    1 point
  4. I've flown several times with my gear, and only once was I given any crap about it... in Lexington KY... the absolute worst TSA checkpoint I've ever been through... Now, I just have my batteries in plastic boxes in my carry-on, and my eGo-styles in my pen-holders of my backpack The reason they don't want them in checked luggage is because the luggage compartment is NOT pressurized... Yet, I have checked luggage with laptops, tablets, and cell-phones before, without any issue... go figure...
    1 point
×
×
  • Create New...

Important Information

Terms of Use Privacy Policy Guidelines