Leaderboard

I agree! I get very nice "clouds" out of the Aerotank V2's I've been using in the car and at work (thanks again, Tam). With a stock 1.8 Ohm coil @ 10.5W (Cloupor Mini), running 50/50 juice... I have to keep the window cracked so i can see to drive That same juice in my Russian, 1.4 Ohm @ 12.5W, and the cloud is even more dense (and quite creamy and satisfying)! I mixed a batch of the same flavor at 30/70, and I'm almost afraid to try it anywhere but at home... I think the cloud rolling out of my car window would be reminiscent of "Cheech and Chong" movies

My New Rig freaking love this tank Got the Mini

If that was the last flavor left on earth id be ok with it,I like it that much

Exactly, Tam... if I had any real $$ invested in it, I would have reason to be upset I think I've done everything within my power to make this work, but it is just too far gone... the build quality of the deck (at least) is probably the worst I've seen in ANY clone over the past year... and I have clones from good and bad cloning companies... I just hope my review will save anyone else from wasting their money on this particular clone, and maybe my comments will find their way back to the factory, so they can address the build-quality? If all of them are this poorly made, Gear Best will be receiving a lot of returns/complaints!

I thought this was gonna be about unopened Pickles lol I have a canned jar in cabinet that been there for about 10 yrs unopened I was wondering if their still good

I have used 80% VG in my KPT2 @ 1.5 Ohm and 1.8 Ohm without issue. YES, you will need to heed Tam's warning about slower wicking, due to thicker juice! Once you fill the tank, allow it to soak the juice for a good 5 minutes (or longer), and chain vaping thick juice will increase the chance of a dry hit or burnt hit... not that it will be a guarantee, but you should be aware it is more possible to happen with higher VG juices.

If you get 70 VG and find that it's a little too thick, you can always get some PG to add to your juice or use distilled water. Add only one drop (or two at most) into your tank and shake well to mix it all up. That will thin out your juice, but it will also affect your vapor production but not by much and you probably won't notice the difference.

I mean you can buy a $10 disposable camera that is waterproof to 50 feet. I assume it contains a Li Ion battery as well. I was just wondering because it has been a long time since I paid any attention to new products since I almost two years into my setup and very happy with it other than needing a way to make it waterproof. Most have survived a quick accidental dunk, left in rain dropped in puddles etc... Vision Spinners are tough as hell and I am amazed how much stronger the Davide glass is compared to KPTs but not tough enough for full no worry water submersion. I would actually prefer it to be a stick style battery even 400 or 600mah would be fine. It just sucks to be floating in the water with a drink in my hand and have to climb back in the boat to take a drag or risk killing a battery. Would be a big $$$ generator should someone come up with a design.

Tam is correct... coil resistance has nothing (really) directly related to vapor production. Resistance (lower) allows for higher Amps, and thus higher Wattage when using a mechanical device. Since you're using a VV/VW device, resistance is not relevant because YOU can set the Wattage or Voltage to provide the power you desire. Using a 1.8 Ohm coil, high VG juice, and setting the Wattage to the sweet-spot of the juice (which may be 7W, may be 15W, who knows... ) will provide you the max in flavor and vapor of the juice. Sure, you can go lower Ohms, even sub-ohms, but VG content is the key to vapor...

Nice! I dig the Smok box

It tastes just like the gum I remember from childhood. You did good! I may need to make an order for 3 mg nic on this one.

I like the way it changes flavors.

Yep. I'm very selective about which juices I use your coils with, Comp. When I try a new juice, I like to use the stock coils just in case. Your Fruitie-Tootie is the juice I'm vaping and I'm quite impressed!

Hey, I've only spent $100 of other people's money this week... (although the week isn't over yet )

Earthling says "you want to spend some money? Step into my office" lol

Sigelei 100w

I've got a variable-speed stir-plate that I used 30-year ago in the chemistry lab (at my old job)... I wonder if it still works? Hmmmm.... I have been known to use the nylon paint-stirrers that you put into a drill to mix batters for cooking... I bet a small one of those (all nylon) on a small cordless drill or cordless screwdriver would work wonders for e-juice mixing!

If you are experiencing reduced airflow on the nautilus mini and the juice is turning dark your coil is burnt...you need to epmty the tank and clean it and start with a fresh coil...also if your juice ratio is too high- say 80vg/20pg it will burn up those coils quick. I know because it happened to me i have both a full size and mini nautilus.

I switched over to .25mg solution on Friday. I think this will be my last few days of vapor...

Not gonna lie,that's pretty damn clever!

I saw a video where a guy took a qtip and cut off one end and cut it long ways and cut those two pieces in half so you have like a propeller type thing.then he put it in a drill and put it in the bottle and voilà! Seems to work pretty well.Its amazing what people can make out of almost nothing.

Tried that, Earthling, but it didn't work so well. *sighs* But on the bright side, I got a great buzz from absorbing the nic through the skin.

Tam, you mean you don't just stick your finger into the juice to make it sweeter?

30mL is $16.50 at most shops in D/FW area. But, watch what they use!