Jump to content

Leaderboard

Popular Content

Showing content with the highest reputation on 01/08/2015 in all areas

  1. Bebop

    Tolerance Break

    Something tells me he's had a few buzz's too many already, lol
    3 points
  2. I worked it out on my Calculator and it was spot on at 50/50. I have to agree with Bebop in that some E-Juice makers do not do things as accurately as they should. I agree with joe go with a 40/60 and see if that is more to your liking. One problem may be your NIC being 50/50 to start with. Next time you order your NIC order 100%vg and at 100mg. I have found that my pg/vg mixes are more on the thicker side when the NIC is also 100%vg. When you use 100mg NIC you will use less and it will last longer at the same price. You will need some 1ml syringes or a 10ml graduated cylinder though. My preference is graduated cylinders for mixing and measuring. If you need a couple PM me and I will hook you up.
    1 point
  3. Earthling789

    Tolerance Break

    Did the profile picture give you a clue?
    1 point
  4. Your profile says you're in the USA yet your IP is in India. Are you a potential spammer?
    1 point
  5. jasonculp

    Sigelei 100 vs IPV3

    I totally agree with the hex screws, and lack of a magnets. Mine came with both hex and phillips screws. I did the 165 watt upgrade and the ohm meter is spot on to .01. (more accurate than my RBA tester) I took it to a buddy who checked it on his fluke, and a much more accurate 4 wire resistance tester used for instrumentation. The battery springs are terrible as they will tear up the covering on the batteries (if you aren't careful). Another problem I found is a nick in the positive wire leading to the battery. Overall I just don't care for it. It is too big for me, and totally un-necessary for the type vaping I am doing. I rarely drip any more, I don't use RTA's any more, and I very seldom go over 15 - 16 watts. It is fun to use though. My nephew came in on leave over the holidays and it was fun to watch him try to hit it maxed out with a .33 ohm dual coil setup on it...lol
    1 point
  6. Tam

    new vaper

    While a Vivi Nova is nice, you might try a bottom coil tank like the Kanger Pro Tank 2 or 3 with an Aerotank base. Add some 1.8 ohm coils, some 40 PG/60 VG juice or 30/70 and you should be getting plenty of clouds. Something else to try would be a Nautilus tank with a 1.8 ohm vertical coil. That gives plenty of vapor without having to go to RDAs or RTAs. Welcome to Vapor Talk.
    1 point
  7. Next time change your mix to 40/60 and see if that helps.
    1 point
  8. 1 point
  9. I have rebuilt a few of mine and there is a fine line between getting it right and having it flood or dry hit.
    1 point
  10. Oh, and the baked onion bacon wrapped? Yeah, I'm trying that one out this weekend.
    1 point
×
×
  • Create New...

Important Information

Terms of Use Privacy Policy Guidelines