Leaderboard

Really depends on the Vaper, and the juice...start low and gradually twist it up till you find your sweetspot. Always turn it down after a new charge, or a new coil.....

CigTechs.com is now selling Tatroe Tanks, which are direct replacements for your Kanger ProTank that hold more juice & allow you to use your own 510 drip tip. They also sell replacement bases for use with specific devices.

Just got home from getting my second stent in a coronary artery. Been over nine years since the last blockage. That is well above the average for people with coronary artery disease. 90% blockage just ahead of where the last 90% blockage was. All you old timers need to find you a good Dr. and stay on top of things because it just sneaks up on you and you just attribute the symptoms to getting old. Once the oxygen rich blood starts circulating it makes you feel like a new person. I have been fortunate that they have found both blockages before I had "the big one" as I don't have any permanent damage .

LOL. Thanks for double checking... But... Yes, the battery is dead. 5 clicks and nothing happens. The good news... The other battery did take a full charge and is working well so far. I hope to get the replacement on Saturday.

I started putting the cotton as the flavor wick itself. I have silica in the coil and the cotton on top of it. You cant make the cotton too thick because it restricts the juice flow. If it is too thin you get leakage and gurgling. You have to figure out what size works after a few tries. It is easy to change so if it is not right just swap it out. Make sure before you put the tube back over it you put a drop or two of juice on it to prime or else you will burn the cotton.

Can't say I have a favorite. Different vendors carry different stuff. Sometimes one is out of stock of something I want while another has it in stock. Depends on what I'm looking for and who has it in stock for what price.

Rixter, I already decided going to get all 3 in the morning to try and review for the board. You all have helped me a great deal only fair I pay a little back :-)

Alas, my street level abode affords me no grander view than such.

Well, don't act so surprised...you knew it was bound to happen sooner or later! I traded a rarely used RBA for it.

*fingers crossed*

Ok to chime in? Are you sure you are turning the battery on? 5 rapid clicks of the button, then the battery should flash a few times and then it will be on. When you charge a Vision Spinner battery that is dead, the battery will flash a few times and then the switch on the battery will light up and stay lit for a couple of hours. About midway through the charge the battery light will go out but it is still not fully charged. The indicator light on the charger itself alternates between red and green as its continuing to charge. Whe it goes solid green its done, about 4 hours total for the 1300. Make sure the charger connection points are clean. Dirty connections can prevent charging.

My Hybrid Elite arrived today.

You can get both styles of units fairly cheap. I think my igo w cost me $15 And my aga cost me $20. welcome to the dark side aqua!!!!' Also you can rebuild your protank coils... That would be a GREAT way to start.

RBA, because I can set it to auto-drip. I can tilt to saturate the wick and vape from the tank, or I direct drip onto the wick and coil.

I had one and sold it. It is a rock solid tank. However i felt it just made my mods too top heavy. Im a cable guy so my pv's stay in the truck. I have a little pouch that they sit in, repurposed vent clip pouch. Most mods sit with 1/3 of the top sticking out the top. With the tatroe tank they had a hell of a lean in the pouch.