Leaderboard

Are your atties gummed up? Tasting like crap? Are you looking for a way to clean your atties without chemical cleaners? Cleaning with hot water has drawbacks as well -- it kills vapor production and if you don't use distilled water you'll have scale build up on the coil which cuts vapor production and shortens its life. Finally, no more waiting days and days for the water to dry out of your atomizer; no more chemicals and no more scale. With the Dooder Method you'll be vaping instantly after cleaning, your atty will taste like brand new, and you'll be saving money! Here's how it works: What you'll need: a. Small saucepan b. at least 2 shot glasses c. USP Propylene Glycol d. heat source e. dirty attys f. tweezers g. paper towels 1. Blow as much gunk as you can from the BATTERY end towards the business end. 2. Place your dirty atties in a shot glass and fill with USP PG to cover the atties completely. Fill another shot glass with pg but don't put any attys in it. You'll need this pg later. 3. Fold up a paper towel, or use some cloth and place in pan. Now, place both shot glasses on the towel, in center of saucepan and fill PAN (not glasses) with water about halfway up the shot glasses. 4. Put on stove or heatsource and set to simmer. DISCLAIMER: As with anything you read on the internet, when trying this method, please use common sense! If using a gas stove, ensure NO FLAME is rolling up the sides of the pan! PG is pretty safe but the vapor can ignite if the concentration is high enough in the room. Good ventilation is key. * The boiling point of PG is 370.8F. What does this mean to you? It means that you will never get it to boil on your stove, but if open flame rolls up over your saucepan you could see a flash. Again, this tech is safe as long as you use common sense. 5. Boil for at least 15 mins. CAUTION: watch and make sure the water level doesnt get too low--it may crack the glass! The lid helps increase the amount of heat inside and helps keep the water level from dropping too quickly. 6. After 15 min. boil, take tweezers and grab and atty from the business end, allowing hot pg to run back into glass. 7. Now, repeatedly dip the atties into the CLEAN hot pg and allow to drain from business end down and out battery end into the glass until it comes out clear. 8. Set upside down on paper towel and allow to cool a few mins. 9. Pick atty up and blow out excess pg. 10. Vape away! Comments or suggestions welcome! Dude.